Getting Started With the ESP32 CAM

Links to the ESP32-CAM
Amazon: amzn.to/3OibrTj
AliExpress: www.aliexpress...
Find me:
Instagram: / 463n7
Twitter: / 463n7_57
Reddit: / 463n7_57
My Tools:
-Hot Air Reflow station: amzn.to/3oOhF33
-Soldering station: amzn.to/3WMUZNs
-Silicon Solder mat: amzn.to/45DY4Dr
-Electric Precision Screwdriver: amzn.to/3C5j88f
-iFixit Pro Tool Kit: amzn.to/42e97QJ
-Digital Microscope: amzn.to/3PxpPYx
My Recording Gear:
-Razer Kiyo Pro: amzn.to/3OPTkVh
-20' USB to USB C Cable: amzn.to/42fpSv2
-Drop PC38X Headset/Mic: amzn.to/42jfLW2
-Camera and Light Arm: amzn.to/43vAFC4
-LED Lights: amzn.to/3CauW96

[@mohammedal-muqimi8562]

Very cool

[@DirtyPlumbus]

I've been sitting on a couple of these boards. Mine didn't come with the programming board and I haven't felt like using the Flipper as a bridge for it.
I found the programming boards available by themselves on Temu. Just waiting for them to show up.

[@UrosGavric]

Thanks a lot! Was unable to program the board until I found your video :)

[@463n7]

Glad I could help!

[@sanketsavani7788]

Can you try to make a concealed camera, or a can you integrate a motion sensor such that it only reacords if there is motion happening and if you could make it portable even better like using the extension of that ribbon connector just place the camera lens and you could hide it even better

[@463n7]

Yeah I'll look into some of this for sure you can get cameras with longer ribbons so they are further removed from the esp

[@alifirdaus6663]

sir pls help me, why my esp32 cam said "no core dump partition found and then its keep loading like this"................................................................................................................" pls help

[@463n7]

posibly the wrong Baud rate. also hold boot when you plug it in.

[@testchannel1834]

I am going to have to order one to test wardrive with it

[@463n7]

Yeah I need to get something put together to see how it works

[@testchannel1834]

@@463n7 just add one of those mini gps RX to pin gpio 5 TX to gpio 17. GND to ground VCC to 3v3. load. side a from wardriver and you should be set

[@umang321]

Where can I find the code for this?

[@463n7]

In the video i walk you through where i got the default code from it was a default in Arduino IDE. you do have to add the ESP32 boards to Arduino.

[@Taieb_Jemal]

Fìrst

[@TheHeldex]

I've sent you a message on IG about a request for arduino/esp32 commission. Not sure if you see it tho?