VW TDI BEW injector removal
Vložit
- čas přidán 29. 08. 2024
- This video is how to remove PD style VW injectors without the VW tool/puller. Credit to BMAC VAGS for starting this method. you can watch his video here • How to Remove VW Golf ...
As always, this is just an idea, you are responsible for your own work on your own car
This is an underrated video, needs more views!
thanks! tell all your friends LOL
Great idea I would add a hose clamp on the pry bar to keep a good angle with the rope while pulling.
Nice trick. Looks a lot better than spending $150
Yeah particularly when you are probably only gonna use it once!
wow, this was very helpful. good camera angle!
Thans so much!!!!
NICE!!!!! THANKS!!!!! LIKE THE GHETTO ROPE & BLOCKS!!!!!!
Usually I am a fan of getting the proper tool but sometimes you just have to figure out how to get something done!
Thxs for your time and knowledge
Awesome video very good explanation, thank you very much!!
Does the bew have an injection pump 2004 Jetta 5 speed
it has a lift pump and a fuel pump but not a timed injection pump like an ALH
Can you do a install video? Or explain how you re install them
the new ones will slide most of the way in. You can put a little oil on them to help. Then when you bolt the holding bock down it snugs it into place. Its just the old ones with carbon build up on them makes it hard to get out. clean ones you can push in and pull out by hand
Oh ok thank you so much!
Do you replace the gaskets when putting them back in?
new injectors should come with new copper crush washers (near the tip) and new O rings at the base of the body. If you are reinstalling the same injectors, i would recommend new crush washers and inspect the O rings. if they have any nicks or deformities, replace them. I have gotten away with reusing crush washers but it is not recommended or preferred. Other than that, Im not sure what gasket you are referring to.
When you replace the injector does get air in the sistem ,because my dosen't want to start now?
mladic86 yes that does happen on the BEW but not near the issue that it is on the ALH. Usually the fuel pump will purge it. Might stumble and a little white smoke but should smooth out after a minute. If it doesn’t start, double check that you plugged everything back in. Also check that your fuel pump is running. You can detach the out going fuel line at the fuel pump and cycle the key. You should get 10-30 seconds of fuel pumping out every key cycle. If not, troubleshoot your intank fuel pump
@@hesty32 thanks for replying 👍
Did you say how many miles were on the car at the time?
345k miles. She’s been around the block a couple times!
@@hestermannmotorwerks wow, i drive a 2004 BEW and only has 120,000 on it. so at 345k i need to swap injectors lol
bro... buy the damn tools so you dont fuck your shit up.
Der engländer hat keine Ahnung