Rocker arms and pushrods LM 7 5.3 L V8.

Guys, hope you’re enjoying the series. Here’s a very important video not to miss sequence on how to install the rocker arms and push rods on an LM75.3 L V8 LS style truck motor pay close attention to the orientation of your crankshaft top dead center and each cylinder what you install for intake and exhaust on each valve. I hope you find this video educational and I hope I explained it the best way I could make sure you guys subscribe to the channel if you like this type of content, make sure you hit the notification bell and check out the Instagram page as well for sneak peaks before the videos. I posted CZcams have a great one. See you on the next one
‪@Gasolinegarage‬
...
Email danolnrcooper@gmail
 [e-mail].

[@dapure1718]

Thank you may God bless you today

[@shaunbunch6503]

Whenever you assembled the engine it should have been set a tdc then you just toss the push rods in make sure there seated then toss on the rocker arms your good to go

[@birdosantana7270]

Best video explanation watched, thank you

[@AarenPho]

Do you have to rotate the crank?

[@coarsegrind]

Would have been nice if you would have shown the lifter preload as well.

[@BigBassChasin]

When torquing down the rocker arms on the second pass what does turning the engine over 360 degrees accomplish? Is that just decompressing the valve springs so you can torque down the rocker arm with no tension on it?

[@Poaf-1]

Why not close em one by one and set em to 22ftlbs ?

[@dalebourgeois9851]

Great video, Thankyou.. I understand that with these engines.. Why is it different with a 5.3 ls engine, which is torque to 22ft lbs?

[@blkstuee7594]

What tool did you use to compress springs like you have??

[@josemonge2869]

Lo pierdes traducir en español por favor grácias

[@josemonge2869]

Español por favor