Intake Manifold Removal | Intake Manifold Cleaning | Honda City IDSi
Vložit
- čas přidán 7. 08. 2024
- In order to do this, you must remove the throttle body. Here is the link below
• Throttle Body Removal ...
In this video ive decided to remove and clean the Intake manifold of my honda city 2008. The in inside of it is not really dirty but decided to clean it anyway. Ive used brush and dishwashing to clean the outside body and just a plain cloth for the intake inside. Cleaned the gasket with dishwashing with soft steel brush for some hard dirt that hard to come off. I was gonna clean the head cover of the valve but i dont have any chemicals for that. if you have any idea how to clean it just let me know in the comments below. Its really nasty looking.
All screws are 10mm except under the intake manifold with 12mm consisting of 2 nuts and 3 bolts
Difficulty Level
7-10
Salamat po sa inyong panood at patuloy na pagsuporta sa Tech DaDiy.
Please subscribe po kung di pa kayo subscribe to sakin.
Thanks po and God Bless sa inyong lahat!!!
/ @techdadiy
TimeLine:
0:00 Intro
0:10 Disclaimer
0:31 How to remove throttle body • Throttle Body Removal ...
0:41 Location of screws
1:53 2 10mm Bolts
2:28 Engine Cover 2 10mm bolts
2:53 Throttle Cable Harness 2 10mm Bolts
3:15 2 10mm bolts at the back
3:37 Front Wire Harness Clip
4:18 Intake 12mm bolt (5th screw)
5:05 Intake 12mm nut (4th Screw)
5:37 Intake 12mm bolt (3rd Screw)
6:15 Intake 12mm Nut (2nd Screw)
6:41 Intake 12mm bolt (1st Screw)
7:09 Upper PCV hose removal
7:48 EGR Hose Removal
9:09 Dip Stick Removal
9:27 Intake Manifold Removal
10:04: Intake Manifold Inspection
11:27 Intake Manifold Gasket Cleaning
12:33 Gasket After Cleaning
12:56 Intake Cleaning
13:43 Putting it all back
14:22 Subscribe
Disclaimer:
Teach Dadiy is not a in any way a Professional or Licensed Technician. This is only a Do it yourself Channel and this page is based ony on observation, experience, and basic knowledge about certain things. You can also try this but at your own risk. Tech Dadiy will not going to be liable in any damage of your units. Viewers Discretion is advised.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
You might also be interested in these
Shell Change Oil Experience
• Shell Ultima Change Oi...
ELM Bluetooth OBD2 Scanner
• Cheap Car Diagnostic T...
How to install Led dome light in car
• How to install cheapes...
How to Install Led Map Light in Car
• How to replace interio...
Shift gear light replacement
• Shift Gear Indicator L...
Car Armrest for Honda CIty
• Car armrest for Honda ...
Car Ceramic Tint
• 87% Heat rejection Car...
Smart Car Battery
• Smart Car Battery | Re...
Reuse of Cabin filter
• Dirty Cabin air filter...
Car Stinking Problem
• Car Stinks?? Cheap Sol...
Car Virtual tour to Centris
• Virtual Drive from Qui...
Car Virtual Tour from EDSA
• Centris to Mindanao Av...
EGR Cleaning
• How to remove and clea...
Throttle Body Removal
• Throttle Body Removal ...
IACV Cleaning Fault code P1519
• Rough Idle na ba? Idle...
#TechDaDiy #IntakeManifold #IntakeManifoldCleaning #IntakeManifoldReplacement #Intake #Manifold
-----------------------------------------------------------------------------------------------------------------------------------------------------------
Music Credit: Music by
/ @joakimkarud
• Mondays by Joakim Karu...
/ joakimkarud
/ joakimkarudmusic
-----------------------------------------------------------------------------------------------------------------------------------------------------------
Microphone: www.lazada.com.ph/products/i9...
Camera: S7 Edge, Canon G6, Sony A6000, Canon 600D, Canon Eos M6
Editing Software: Wondershare Filmora - Auta a dopravní prostředky
That's dirty, I need to clean my Civic i-DSI asap! Thanks for the video
Yup. Its kinda dirty. Its much better after cleaning ☺
You might also be interested in these
Shell Change Oil Experience
czcams.com/video/te0HRDgc-ok/video.html
ELM Bluetooth OBD2 Scanner
czcams.com/video/d-LNfZQ5v7Q/video.html
How to install Led dome light in car
czcams.com/video/aoMkYggb1fQ/video.html
How to Install Led Map Light in Car
czcams.com/video/m7cliFkOdOE/video.html
Shift gear light replacement
czcams.com/video/otQD4rV4lOw/video.html
Car Armrest for Honda CIty
czcams.com/video/YC50KZQ7cNk/video.html
Car Ceramic Tint
czcams.com/video/6eYjI1c7jB4/video.html
Smart Car Battery
czcams.com/video/hkH0WfABvhY/video.html
Reuse of Cabin filter
czcams.com/video/Z-nYaPJpMo8/video.html
Car Stinking Problem
czcams.com/video/_qhAfa9Gse8/video.html
Car Virtual tour to Centris
czcams.com/video/YsYXyBGFR-A/video.html
Car Virtual Tour from EDSA
czcams.com/video/jYHrer2XjU8/video.html
EGR Cleaning
czcams.com/video/Tsycz3stc4A/video.html
Throttle Body Removal
czcams.com/video/Mqne2tdmzN4/video.html
IACV Cleaning Fault code P1519
czcams.com/video/zrful-4VPwY/video.html
Great video lods,ngayun bubuksan ko narin manifolds ng Honda city ko jejej tnx talaga lods....
Goodluck boss. Kaya nyo yan
Super!!!!
Nice
Thanks
Nice..
Good video
Thank you sir
Hi there I am having some issue. I have same car but I don't have two of the metal gaskets, I have only one that is attached to the engine. Is there suppossed to be two of them with the plastic one in the middle? thanks
i think there shoud be two. one is the bigger thicker one and the other is a very thin metal sheet supposed to be a intake gasket.
@TechDaDIY Thanks so much. Does the thin metal sheet go behind the thicker one?
Boss ok lang ba di na lagyan ng rtv silicon pagbalik ng intake manifold? Nalinisan ko na first time e di na rin ba ako maglagay ng rtv silicon?
I think di na kailangan. Kasi may rubber gasket naman. Pero mas ok din siguro may silicone para mas silicone para mas sealed. Not sure lang kung advisable.
Hey bro. Great video and nice tutorial although not in English. Btw Im from Malaysia. Did u get a high rpm after the cleaning? And if yes how do u fix that? By unplug the battery terminal?
Sorry if it isnt english. There was no problem after cleaning. No i didnt have the high rpm.
ask ko lng anong type of transmission yong car mo?
Matic boss
Great video. A shame not in English..Did you clean the intake manifold and inside of it (the black removed part)? And with what?
Thanks :)
Sorey for that.I will try to add some subtitle in the future. I did clean it with just a rug i found since its not so dirty inside. I just snug a hose and fit into the rug and clean it inside
Thank you for replying and no problem at all.
I learnt allot from this video and will attempt to do the same with my Honda Jazz.
Did you have to replace any Gaskets?
what is the torque spec of the intake manifold bolts
16 ft/lbs
I dont have tools to measure but i make sure its tight enough
what size bolt nut ng intake manifold? thank you
12mm
Para makuha ang pcv assembly last tangglain ang starter pero luwagan muna ang radiator or condenser..
Thats maybe another way of removing it
@@TechDaDIY tiningnan ko gawa ng mekaniko ko pag kuha nya sa pcv tinanggal nya ang starter kasi nasa likod ang pcv assembly .
@@jeromepacana3928 eto naman sakin sir
czcams.com/video/65sPs9ONifY/video.html
@@TechDaDIY ganyan ginawa ko boss hinila ko shortcut dati nabasag ginawa ko dinikitan ko ng otso otso kasi wala benta dito pcv saka punta ako davao . Yun diskarte nila tanggal starter at ang condenser hinila lang kunti ayun libre mo na makuha ang pcv assembly..
Walang ads..
Meron naman hehe
ano pong mararamdaman sa makina kapag nalinis po itong parts?
Mas pino boss ung arangkada. Parang wala ng pumipigil. Kumbaga sa ilong maluwag daluyan ng hangin
@@TechDaDIY parang gusto ko na rin magDIY dahil sa mga videos nyo. Salamat
Sir okay lang pa yun ebalik ang gasket? or pwede rin palitan ng bago?
Much better boss if meron ka replacement
magkano gasket ngayon ser? yung sakin kaso pagtanggal ko manifold puro sealant bakit kaya ganun, pede bang inde na lagyan sealant
Di ko sure boss e. Ung sakin kasi binalik ko lang ung mga gasket nya. Mas ok boss meron
@@dgoodsamarites intake manifold gasket 1K po..meron sa mga autoshop
@@TechDaDIY ser anong ginamit mong panlinis sa loob ng manifold? kerosene po ba