GT2 TIMING PULLEY | FUSION 360 TUTORIAL

GT2 TIMING PULLEY.
What is GT2 timing pulley?
GT2 Timing Belt Pulley is widely used in the 3d printer. ... This pulley has 20 teeth and a 5mm inner bore. Two set screws can be used to attach it firmly to any 5mm diameter shaft. Full aluminum construction means these are very light and very durable.
#GT2
#pulleys

[@j33pguy]

Thank you for your hard work, these videos are great!!! Keep up the good work.

[@daxmakes]

Thank you, Muammar! It's great to learn by watching someone so proficient with F360. :)

[@josephclifford3297]

Super fast, straight to it. Nice.

[@arnabdasgupta5695]

Nice Video

[@piotrwyrw]

Where did you get the dimensions from?

[@shivamchaurasiya1716]

Pls upload video drone structure and different defferent simulation parameters pls

[@aman72kamboj]

tks

[@leonsplaylife]

Couldnt locate the insert. What is the part number?

[@gonzalodutrasilva]

Hello how are you, I loved your video, but I have a problem, where do you get the 0.195mm? Thank you very much.
Hola como estas, me encanto tu video, pero tengo un problema, de donde obtienes el 0.195mm? Muchas gracias

[@SPARKPLUG98]

Please tell me time stamp

[@gonzalodutrasilva]

@@SPARKPLUG98 In 1:50

[@SPARKPLUG98]

It's just a distance , it is as it is

[@MANCHILDMD2020]

It looks like it is the total depth of the tooth minus the radius of the tooth. .75-.555+.195 this gives the off set placement of the tooth center below the OD of the drive pulley. From the GT2 schematic

[@joeyn.8379]

too fast and not exactly worked and described by the scrub screw