The heavy brass thrust washer should be removed immediately after the propeller and kept with the other parts. It is a vital component of of the prop reinstall process. Don't lose it. Regards.
Thanks for watching & welcome to the DIY Raptor Club. Great advice & we appreciate you sharing. We completed a full lower unit rebuild recently, videos coming in May. Hope all is well.
@@DIYwithMichaelBorders I haven't done anything further yet because I'm waiting on replacement parts, as it sits o can still drive it so I may take it out this weekend. I will post here next week once the parts get in and I remove it. I feel like a most likely will need to cut it off.
@@vinny1028 We appreciate the follow up, we know all too well about drilling 🤣 Not sure if you’ve seen our video on removing the Bearing Carrier. Link below. czcams.com/video/pWJ8lpVvu4A/video.htmlsi=lisNEFcPAMl2op8- 😁👍🧰
Hey Chuck, thanks for watching. Any update? Hopefully it’s just corrosion buildup as opposed to melted aluminum from overheating engine. Keep us posted. 😎👍
@@DIYwithMichaelBorders I got the splined brass spacer off but the propeller is frozen on the shaft and won’t slide off. I used a makeshift puller to no avail. I stopped before I hurt myself. Either I need to order a good puller or hire someone
1. BEST outdrive stand assemble/review
czcams.com/video/gLBQvjiYaEk/video.html
The heavy brass thrust washer should be removed immediately after the propeller and kept with the other parts. It is a vital component of of the prop reinstall process. Don't lose it. Regards.
Thanks for watching & welcome to the DIY Raptor Club. Great advice & we appreciate you sharing.
We completed a full lower unit rebuild recently, videos coming in May. Hope all is well.
Lock nut was on backwards?
My tab washer receiver is stuck on. I've hit it with a hammer, tried to pry it. Used heat, wd40 to no avail. Do I need to cut it off?
Good morning ☕️ any update? We have been there, that’s never fun. Please keep us posted, a bit more heat may help.
@@DIYwithMichaelBorders I haven't done anything further yet because I'm waiting on replacement parts, as it sits o can still drive it so I may take it out this weekend. I will post here next week once the parts get in and I remove it. I feel like a most likely will need to cut it off.
@@vinny1028
😁👍
Had to drill a hole in the washer receiver and split it open to get the prop off. The washer welded to the prop
@@vinny1028
We appreciate the follow up, we know all too well about drilling 🤣
Not sure if you’ve seen our video on removing the Bearing Carrier. Link below.
czcams.com/video/pWJ8lpVvu4A/video.htmlsi=lisNEFcPAMl2op8-
😁👍🧰
how tight should i tighten the bolt back on?
My spacer is froze on the shaft
Hey Chuck, thanks for watching. Any update? Hopefully it’s just corrosion buildup as opposed to melted aluminum from overheating engine.
Keep us posted. 😎👍
@@DIYwithMichaelBorders I got the splined brass spacer off but the propeller is frozen on the shaft and won’t slide off. I used a makeshift puller to no avail. I stopped before I hurt myself. Either I need to order a good puller or hire someone
@@chuckwebb7564
Thanks for the follow up. We know the feeling. If you continue watching our rebuild videos, you can see the fun we had. 😁👍