😱 THIS IS NOT POSSIBLE! How to make ROUND mirror chassis?
Vložit
- čas přidán 18. 03. 2023
- Round mirror frame for hall in carpentry.
In this video I show step by step how to make a round joinery chassis with glued mirror without border.
I show 2 very interesting techniques that are done on a table saw (square saw), which would be how to make a circle in mdf and how to bend an mdf batten.
The circular mirror frame or round mirror, was produced for an entrance hall, but works for many other environments, such as bedroom and dressing room.
If you liked these techniques, please leave your like and subscribe to the channel.
Share: • 😱 Isso NÃO pode ser po...
Instagram: / rote_woodwork
CZcams channel: / @rote-woodwork
Other videos that may also help you:
You've NEVER seen this! Amazing CAVA HANDLE idea!
• Você NUNCA viu isso! I...
ATTENTION! Don't make a sliding door before watching this video!
• ATENÇÃO! Não faça port...
[STEP BY STEP] How to install LED TAPE PROFESSIONALLY!
• [PASSO A PASSO] Como i...
STOP! Avoid WASTE of edge tape with this TOOL!
• [PASSO A PASSO] Como f...
INCREDIBLE! New JIG to cut battens ALONE and SAFELY!
• Guia FEATHERBOARD! Voc...
SECRET REVEALED! How to make a PERFECT 45 degree cut the SIMPLE way!
• SEGREDO REVELADO! Como...
??Make R$1500.00 by making this BATHROOM CABINET! (Full project)
• 💲FATURE R$1500,00 faze...
URGENT! You NEED this NOW in your joinery!
• 🚨 URGENTE! Você PRECIS...
#mirror,
#mirrordecoration,
#roundmirror,
#mirrors,
hallmirror,
Produto usada para colar o espelho, COMPRE AQUI: shope.ee/1q9HHT69dg
Amazing. from Miami Fl USA
Ficou muito bom. Parabéns 👏 fiz um vídeo sobre móveis curvados também
Obrigado
Excelente trabajo, gracias por compartir.
Gracias
Curvar MDF,essa ideia foi incrível, parabéns
Muito obrigado pelo comentário miau miau.
verdadeiro mestre de magia oculta.
Obrigado
Muito bom
Obrigado
Top👏🏾, vou tentar fazer
Obrigado, pode fazer, você vai conseguir!
Boa noite, parabéns pelo trabalho.
Muito Obrigado varlei, amanhã 5 e 15 tem vídeo novo no canal.
@@rote-woodwork ok Deus abençoe.
Quando eu faço isso,quando eu vou dobrar ela quebra
Tenta fazer corte de 1 em 1 cm e quando for passar esses canais, deixa a serra 1.5mm mais baixa que a espessura do mdf. Claro que se for uma curva muito curta, acho que não sera possivel.