this video came in clutch, I forgot where the brake booster vacuum went to in the intake manifold and you had just the right angle for me to see where it went. Thanks big dawg
I’ve got a 77’ and got a 32/36 in tonight and had a HORRID stock carb on it. This video was perfect and made the swap make much more sense with the little details. Good video!
Love the chinook, I have a 77. I put the exact Weber on my 20r and it was a huge improvement. Just swapped in a 22r and swapped the Weber over. Not running as great as it did on the 20r. Still trying to figure out the issues.
👋 Ray.....Lindalee here....... Question: about my Chinook again.... When you put the thermostat gasket in do U put thermostat with little pop up air hole towards windshield n & then gasket or do U put gasket then put thermostat ontop of gasket? 👌 ran my battery down, can not time it myself anyway, but, still have to flush gunk I think after putting new gasket on water pump. Have a place that will time it & adjust carb, but; they will have to charge battery. Only $100 they said, then; tell me if it needs anything else. Question: I saw this stuff COIL CLEANER a guy used for air conditioner coils & thought buying the stuff spraying on radiator in Chinook. To clean it. Although I have with hose looks OK outside, might be loaded gunk inside. Please tell me what U think. Respected, 💋😘Lindalee
@@rwallaceiv We have a 75' that's great but has an issue with the front tires rubbing against inside of wheel wells when cornering on uneven pavement. Any idea what could be causing that?
We have a 75' that's great but has an issue with the front tires rubbing against inside of wheel wells when cornering on uneven pavement. Any idea what could be causing that?
Do you have over sized tires? that could cause it, or your front shocks are so tired and weak that they sag, perhaps check alignment, and if you have 2wd then the front can be adjusted with height by adjusting the torsion bars.
@@rwallaceiv Thanks much buddy! I had not considered the torsion bars, so will give that a shot. The shocks look okay, and aren't leaking but wheels are slightly wider than stock. Will mess w the torsion bars first and see what that does... and will let you know. Thanks much!
👋 My CHINOOK is 1977. It ran good. But, I waited t replace water pump slow leak. I bought a gasket had to be BRAVE. Cleaned out reservoir, flushed radiator all clean running out of engine.. Is there. A air pump to keep the engine cool? Or is it the fan & radiator? I put reservoir green ANTIFREEZE, as both O'Reilly & Autozone said too. It runs now new water pump gasket used old pump, cleaned it, spinning good. It warmed up, burped Then it chugga lugged after I stepped on gas pedal. HELP! OPINION? 💋😘 70 YR. YOUNG New at this 😊😃
Chug a lug after stepping on gas pedal could be fuel delivery, or clogged carb, have you addressed those issues before continuing? And perhaps a timing,? I made a video on how to time the engine. Go check it out
👋 saw timing 📹 I looked found the line between the pully & fan belt. It is way off to the left. My engine is warm, no choke on, want to loosen distributor to turn. Want to listen to engine, how it sounds then tighten once line moves over. Any advice? 💋😘
@@rwallaceiv 75 degree reading on your device. But do not have one. That line is far to left. I want to let engine warm, loosen bolt on distributor then turn slightly to right see, listen to engine. Check line if it moves to right like your video. 👌 YES, go for it.? PS does distributor adjust timing BELT. Stupid question 😒🙄 have no idea what I am doing. Just no money. ❤💙💜 my truck so dependable. 💋😘
@@lindaleehulsey3167 I wouldn't take it out. Because there are certain steps to get it back aligned. You should get a weber carb. It will probably fix all your problems
I'm getting ready to do this today on my 77 Chinook as soon as my Weber shows up, this came in clutch!
Hope it helps
this video came in clutch, I forgot where the brake booster vacuum went to in the intake manifold and you had just the right angle for me to see where it went. Thanks big dawg
I’ve got a 77’ and got a 32/36 in tonight and had a HORRID stock carb on it. This video was perfect and made the swap make much more sense with the little details. Good video!
Cheers mate!
Love the chinook, I have a 77. I put the exact Weber on my 20r and it was a huge improvement. Just swapped in a 22r and swapped the Weber over. Not running as great as it did on the 20r. Still trying to figure out the issues.
What did you do with the hoses from the smog pump underneath? Did you block the holes some how?
unbolted the smog pump, and trashed smog items, block off plates from LCE engineering for smog delete
👋 Ray....Lindalee
Awesome video, planning to do the same set up on my 78'. Did you use both block plates and all of the block plugs from LCE?
yes, block off plates from LCE, be sure to order the plugs too, those screw in water fitting plugs.
@@rwallaceiv Cool, thanks! Did you install a new fuel pump since the weber needs 2-3 psi?
@@Matt-rl5mx nope. Runs just fine with stock pump. No over pressure problems
Did you ever hook the evap canister solenoid up? Im not sure what to do with it.
Yeah I think I left that, I didn't know what it did.
👋 Ray.....Lindalee here.......
Question:
about my Chinook again....
When you put the thermostat gasket in do U put thermostat with little pop up air hole towards windshield n & then gasket or do U put gasket then put thermostat ontop of gasket?
👌 ran my battery down, can not time it myself anyway, but, still have to flush gunk I think after putting new gasket on water pump.
Have a place that will time it & adjust carb, but; they will have to charge battery. Only $100 they said, then; tell me if it needs anything else.
Question:
I saw this stuff COIL CLEANER a guy used for air conditioner coils & thought buying the stuff spraying on radiator in Chinook. To clean it. Although I have with hose looks OK outside, might be loaded gunk inside.
Please tell me what U think.
Respected,
💋😘Lindalee
great video.
what tires do you have on?
BUCKSHOT MUDDERS 27 INCH
@@rwallaceiv they fit the stock rims and fender clearance is all good?
@@Ty-yz2kd stock rims yes, and does not rub, full clearance
@@rwallaceiv We have a 75' that's great but has an issue with the front tires rubbing against inside of wheel wells when cornering on uneven pavement.
Any idea what could be causing that?
We have a 75' that's great but has an issue with the front tires rubbing against inside of wheel wells when cornering on uneven pavement.
Any idea what could be causing that?
Do you have over sized tires? that could cause it, or your front shocks are so tired and weak that they sag, perhaps check alignment, and if you have 2wd then the front can be adjusted with height by adjusting the torsion bars.
@@rwallaceiv Thanks much buddy! I had not considered the torsion bars, so will give that a shot.
The shocks look okay, and aren't leaking but wheels are slightly wider than stock.
Will mess w the torsion bars first and see what that does... and will let you know.
Thanks much!
what is the red stuff you put on the gasket?
It is a permatex gasket sealer. amzn.to/38UhjA9
Do you still have the carburetor and how much would it be
I sold that one. But I have another. But it might need a cleaning
nice honcho jeep j10
I happen to have a 77 as well but right now I am having a rough time with her idling and she's also not doing too hot as well
ill sell ya my rebuilt oem carb, runs great
@@rwallaceiv is it a manual choke if it is then I'll need the choke Linkage as well because I don't think mine has it
And if so how much
@@Red_Alpha_Fox3358 Its auto choke, uses the water hose line, stock
@@Red_Alpha_Fox3358 75 bucks
What size are those tires?
27 inch tires
Can you send me a link where to buy the carburetor?
LCE Performance, Lake Havasu
Do you still have the original carburetor
No sold
But I have another one waiting to be rebuilt if ya want that one.
👋 My CHINOOK is 1977.
It ran good. But, I waited t replace water pump slow leak.
I bought a gasket had to be BRAVE.
Cleaned out reservoir, flushed radiator all clean running out of engine..
Is there. A air pump to keep the engine cool?
Or is it the fan & radiator?
I put reservoir green ANTIFREEZE,
as both O'Reilly & Autozone said too.
It runs now new water pump gasket used old pump, cleaned it, spinning good.
It warmed up, burped
Then it chugga lugged after I stepped on gas pedal.
HELP!
OPINION?
💋😘 70 YR. YOUNG New at this 😊😃
Chug a lug after stepping on gas pedal could be fuel delivery, or clogged carb, have you addressed those issues before continuing? And perhaps a timing,? I made a video on how to time the engine. Go check it out
@@rwallaceiv thank 😊 U so fast.....
Gonna see.......
💋😘
👋 saw timing 📹
I looked found the line between the pully & fan belt.
It is way off to the left.
My engine is warm, no choke on, want to loosen distributor to turn.
Want to listen to engine, how it sounds then tighten once line moves over.
Any advice?
💋😘
Yes follow my video, I can't remember what degree, match that degree and then retighten the distributor
@@rwallaceiv 75 degree reading on your device.
But do not have one.
That line is far to left. I want to let engine warm, loosen bolt on distributor then turn slightly to right see, listen to engine. Check line if it moves to right like your video.
👌 YES, go for it.?
PS does distributor adjust timing BELT.
Stupid question 😒🙄 have no idea what I am doing. Just no money.
❤💙💜 my truck so dependable.
💋😘
@@rwallaceiv 👋 🌄
can I pull distributor out to put points in B4 turning for timing.
@@lindaleehulsey3167 I wouldn't take it out. Because there are certain steps to get it back aligned. You should get a weber carb. It will probably fix all your problems
@@rwallaceiv thank U 😊 do U have a good sales reference. Know they are pricey always wanted one.
💋😘
How much are you asking for the carburetor
Sold already. Sry
You ever sell that carb?
It sold, I have 1 more. But it needs a cleaning.
Do you have the chinook still ?
I still have it, I drove it today!
@@rwallaceiv I was wondering if you had Instagram
@@diegopadilla6489 Instagram is rwallaceiv and I have a bunch of chinook stuff on it too
@@rwallaceiv thanks bro
@@rwallaceiv I followed you