it probably takes years for people to figure some of the little details out. i couldnt get my sprayer to air purge the booms at the end of the day. after a while i realized it does not let you apply anything outside of boundry.
The 4640 display has a built in brain that it will work outside of a piece of equipment? I was told it wouldn’t work and would need a 2630 display to do that? I wanted to mount a setup on a Can-am Defender and a 4640 will work then?
It should you just need a harness. Can get one at your deere dealer just tell them what you're wanting to do. Just got set up on my polaris ranger and been playing with it the last few days
Yes. To make a boundary on a GS3 2630 click on the Menu button, GS3, Mapping, and then the Boundaries tab at the top of the screen. To make AB lines click on the Menu button, GS3, Guidance, and then the Set Track 0 button at the bottom.
You you swerve on your boundary line at all then your ab line will not be the same as the boundary and shut rows off
it probably takes years for people to figure some of the little details out. i couldnt get my sprayer to air purge the booms at the end of the day. after a while i realized it does not let you apply anything outside of boundry.
Wouldn't your AB line by 3 feet off from your boundary? Since you put in an offset for the boundary but I assume didn't for the AB?
what is the area that you can cover in 1 hour?
The 4640 display has a built in brain that it will work outside of a piece of equipment? I was told it wouldn’t work and would need a 2630 display to do that? I wanted to mount a setup on a Can-am Defender and a 4640 will work then?
It should you just need a harness. Can get one at your deere dealer just tell them what you're wanting to do. Just got set up on my polaris ranger and been playing with it the last few days
Can you make your boundary and set your AB line on a 2630?
Yes. To make a boundary on a GS3 2630 click on the Menu button, GS3, Mapping, and then the Boundaries tab at the top of the screen. To make AB lines click on the Menu button, GS3, Guidance, and then the Set Track 0 button at the bottom.