Though the job is done, after the work that part becomes stiff and no longer flexible.Linking the tracks with thin insulated wire would give more flexibility.
Hi bro, that's amazing recovery. I have a flex ribbon which requires some workm any chance I can ship it over to you for you to have a look? Let me know bro. Thanks
I place clear plastic heavy duty tape over the repaired cable to also limit flex and support the cable
I ran out of my thermal tape😑
Economical
So did you scape the coating off with heat ? Or just used the tool alone ?
looks good, the flux was important?? 5 ribbon circuits???
Yes
How many degrees you use on your soldering iron.I am afraid to burn the ribbon cable with to high heat?
It wont burn, just apply by heated lead
Can u name 2 type paste that u use? The brand
And can I use regular tape in place of gum you added at last?
Depends on how hard it will hold
@@MrBiomedical what fluid u used after cleaning the flex and is it compulsory?
It is UV mask. It is necessary to bond the connection
Though the job is done, after the work that part becomes stiff and no longer flexible.Linking the tracks with thin insulated wire would give more flexibility.
Yes true. But for my application it was enough. That is what
Hi bro, that's amazing recovery. I have a flex ribbon which requires some workm any chance I can ship it over to you for you to have a look? Let me know bro. Thanks
Yes, you can send me. More details please WhatsApp 9790567867
when can I find replacement flex cable?
what did u use to clean it up?
I am using NC Thinner
what do you scratch the ribbon with?
Blade
What fluid you applied after cleaning the flex
special uv light glue specially for this aplication
dont know what its called exactly
@@bassfear_9952 so can I use tape in place of this glue
@@brahmanroadjorhaturban1498yes, preferably thermal resistant capton tape
UV mask
It is called UV mask
What’s the name of the song?
Cocomelon theme song
What is the name of that fluid??
Which one?
what's the white paste stuff you used that made the lead only stick to the pins and not anywhere else on the flex cable?
Soldering flux only
Good video
👍
So why do we apply uv light?
The name itself telling UV mask. So that it will get strength bond
@@MrBiomedical
Thank you for the information
Can broken tiny leads be detected visualy in flex cables?
This is an old type of the ribbon cable. Most of modern ribbons cannot be soldered.
Yeah i guess
Perfect
Thanks
I have to do that on a flat cable about 5 times smaller than that 😅
Then u should need that level microscope
Is it a problem if one path connected to the one beside it ?
Not a problem until you connected it correctly
@@MrBiomedicalso if a solder connected two paths wont be a problem? Because it is spaces between paths are so narrow
@ztipster in that case u should need to use number wire
@@MrBiomedical what is number wire ?
Sorry, jumper wire I meant
Minute soldering..lvlu😎😎
Micro soldering🔥