New Cybertruck Accessories Installed

Sdílet
Vložit
  • čas přidán 21. 08. 2024
  • I received a few accessories for my Cybertruck. Here is a quick install video. Enhance both style and functionality with these essential accessories for your Cybertruck.
    For anyone that is interested in getting the running boards or any other products from EVBASE, here is the link:
    www.evbase.com...
    **EVBASE 20% Discount Code: LENNY
    List of accessories installed on my truck:
    Rough Country Rubber Molle Panel Clamp Kit - amzn.to/4eDxTkU
    Tesla Cybertruck Lug Nut Covers & Center Caps - amzn.to/3RHuLut
    Lower Armrest Organizer - amzn.to/3VFQfJi
    Gas Can and Water Mount, Tactical Rigid MOLLE Panel: amzn.to/3Aki8iV
    RotopaX RX-1W Water Pack - 1 Gallon: amzn.to/4cq75SJ
    Kidde Auto Fire Extinguisher for Car & Truck: amzn.to/4cDGOAF
    Quick Release Fire Extinguisher Mount: amzn.to/3X0vD08

Komentáře • 8

  • @geraldsellers9096
    @geraldsellers9096 Před měsícem +1

    Lenny put a nice medical kit back there. Also look into swag tents way better quality the the old school tents of the past. Swags are new to Americans they come from Australia and we know they know a thing or two about the outback.

    • @LennyK
      @LennyK  Před měsícem

      Thank you for the feedback on the Swag tent. I will definitely need a second one for two people. As for the med kit, it’s part of my grab bag already that I carry in the frunk including trauma kit, and turnicate, just in case.

  • @justonbrazda3846
    @justonbrazda3846 Před měsícem

    Why don’t I have those tie downs on my bed floor? Mine are just plastic caps with bolts below

    • @LennyK
      @LennyK  Před měsícem +1

      Good question. I would check with your local Tesla location where you picked it up from. You definitely should have them.

  • @pedrohizzle2835
    @pedrohizzle2835 Před 10 dny

    what did you do at 5:29? I can only get mine into go in one side

    • @LennyK
      @LennyK  Před 10 dny +1

      The brackets on both sides are very tight (properly fit). So what I had to do is push both sides in little by little (one at a time) while only partially engaging the latch until both sides are in. As you kinda see later in the video.

    • @jlevitsk
      @jlevitsk Před 8 dny +1

      @@LennyK Some trucks have an issue with the floor being too high. My service center was able to adjust the floor and my bed divider works good. I still put one end in and then push down a little on the other side as I lock it in but it didn't fit at all before the service center took a look.

    • @LennyK
      @LennyK  Před 8 dny

      @@jlevitsk Glad you go it figured out