How To seal Your Sump Pump To Avoid Bad Smell In Basement- Do It Yourself

Sdílet
Vložit
  • čas přidán 15. 10. 2021
  • How To seal Your Sump Pump Lid - Avoid Bad Smell In Basement - Do It Yourself Or How To Seal A sump pump cover to avoid smelly basement shows how to seal a sewage sump pump cover to avoid bed smell or sewage smell.
    Materials and tools used:
    Sunp Pump Rubber Sealer amzn.to/3DMTkwn
    Pro Caulk = amzn.to/2G6GKQj
    Silcon white = amzn.to/2HLKAiO Silicon Clear = amzn.to/2Johpmx
    Silicond almond = amzn.to/37gjjOi
    Amazon Deals:
    Try Amazon Prime 30 days for free = amzn.to/2JMWaLe
    Create Amazon Business account = amzn.to/3mLSyYt
    Joint Amazon Prime Watch Thousends Of Movies and TV = amzn.to/33NfsHD
    Try Personal Shopper Wardrobe amzn.to/2VClfv9
  • Jak na to + styl

Komentáře • 17

  • @josephk9182
    @josephk9182  Před 2 lety

    Sunp Pump Rubber Sealer amzn.to/3DMTkwn
    Pro Caulk = amzn.to/2G6GKQj
    Silcon white = amzn.to/2HLKAiO Silicon Clear = amzn.to/2Johpmx
    Silicond almond = amzn.to/37gjjOi
    Amazon Deals:
    Try Amazon Prime 30 days for free = amzn.to/2JMWaLe
    Create Amazon Business account = amzn.to/3mLSyYt
    Joint Amazon Prime Watch Thousends Of Movies and TV = amzn.to/33NfsHD
    Try Personal Shopper Wardrobe amzn.to/2VClfv9

  • @CityBoyCountryHome
    @CityBoyCountryHome Před rokem +1

    Bummer that others are complaining. This video was super helpful. This was the only place on the internet that had the seal - I couldn't find this at the box stores. So thank you for the amazon link to the seal. I didn't have to cut it because theres a check valve-union-valve on my discharge line. I didn't do any additional caulking - there was some kind of caulk on the seal I replaced and its obvious it ultimately didn't do much. I just ordered two additional seals for when I have to replace it again. Thank you for this video, made my job super easy!!!

  • @RICHIE_RICH89
    @RICHIE_RICH89 Před 9 měsíci +1

    Thats the ejector pit or trash pump. Sump pump pits usually do not have the bolted down covers. Thats where shit ect goes then gets sent up and out.

  • @oOohdaddy
    @oOohdaddy Před 11 měsíci +1

    Very honarable video 😂 and im gona trademark the word "here" so i can get rich 😂😂😂 all jokes aside thank you for the video didnt even know or look at my sump pump but i have noticed smell hence why im here

  • @Z-Ack
    @Z-Ack Před 8 měsíci

    Why didnt you silicone the entire thing including around the pipe? Is also a good idea to install a water alarm unless you have an auto overflow syphon system installed for overflow/ flood protection..

  • @RICHIE_RICH89
    @RICHIE_RICH89 Před 9 měsíci

    Should of resealed all of it. If part of the seal failed the rest is ready too

  • @bradw.5991
    @bradw.5991 Před rokem

    I am just trying to understand the piping setup? Obviously you have a discharge pipe to a check valve to outside, but the other pipe that comes in kind of confuses me. At first I thought it might be a backup sump discharge line going to a sanitary line inside the wall (that would be the reason for the drain trap) but still not sure what the line connected above it goes to - a vent? The reason you are getting nasty smells from your sump pump crock is the water in the drain trap is drying out and the sanitary flue gases are traveling back into the crock. Very bad setup.

    • @josephk9182
      @josephk9182  Před rokem

      There are 2 pipe one for swage and the other for air. There is nothing wrong with the setup because it is normal setup. The led should be sealed that swage gas will only go out via the air pipe.

    • @CityBoyCountryHome
      @CityBoyCountryHome Před rokem

      Yes the second line is a vent. This setup is fine and basically standard other than theres no union so he had to cut the seal.

  • @farukatasever2933
    @farukatasever2933 Před 4 měsíci +1

    👍👏Also ,good idea to clean inside the sump pit minimun twice a year or so.

  • @thomasridley6591
    @thomasridley6591 Před rokem

    Not very helpful. While I understand the concept & installation of a seal, you don't show how you installed it. This was a lesson on how to use bolt and washer.