Reviewing of XH M229 desktop power supply box ATX power transfer board UPDATED 2021

Sdílet
Vložit
  • čas přidán 21. 08. 2024
  • Reviewing of XH-M229 desktop power supply box ATX power transfer board UPDATED 2021
    XH-M229 desktop power supply box ATX power transfer board, take out the electrical outlet module, power output terminal.
    Product Name: ATX power supply switch board
    Model: XH-M229
    Compatible port: ATX (compatible part BTX type)
    Switch: there is
    Output number: four sets of different voltages
    www.aliexpress...
    WARNING:
    This video is for demonstration and education purpose only. Each demonstration presents risk and hazards that must be fully understood before attempting.
    And should be performed only by professionals
    Disclaimer:
    The information, demonstration and any content contained in this video is for informational purposes only. PLEASE READ Warning… do this at your own risk. I am not responsible for what you do to your device.
    MUSIC:
    Track title: Kurt
    From: CZcams Audio library
    IMAGE:
    Quranic Dua #35 (Surah al-Ahqaf)
    From: quranicquotes....
    I have approval from the site quranicquotes.com to use the images

Komentáře • 9

  • @cc9919
    @cc9919 Před 2 měsíci

    Is connecting - 12v and +12v can be use as 24v output?

  • @electronicajean727
    @electronicajean727 Před 2 lety +1

    como hacer circuito impreso PCB tu compraste en aliexpress este yo queria hacer 20 Placa

  • @HuaweiBaru
    @HuaweiBaru Před 2 lety +1

    after you shorted it, did you change the fuse?

    • @LEQSBeaprofessional
      @LEQSBeaprofessional  Před 2 lety +1

      I did not change the fuse, and the fuse was not damaged

    • @HuaweiBaru
      @HuaweiBaru Před 2 lety +1

      @@LEQSBeaprofessional how it came, you shorted it and was not damage the pcb as well?

    • @LEQSBeaprofessional
      @LEQSBeaprofessional  Před 2 lety +2

      Most of the power supply devices currently contain protection circuits against the short circuit using the MOSFET, relay, or otherwise, depending on the design, so that when a current is drawn higher than the power supply current, the circuit is disconnected.