Ford 300 Inline 6 Engine Rebuild Part 8: Head and Manifolds
Vložit
- čas přidán 8. 12. 2022
- Please SUBSCRIBE so you don't miss new releases!
Installing the head on an engine can be a daunting task - but with some research and planning, it’s very doable. In this video we install the head onto my 4.9L ford, and then we get the intake and exhaust manifolds installed as well. These are the last major steps before it’s time to get the engine into the truck!
*Please remember, I am NOT a mechanic. I am a hobbyist, and so I may make mistakes in my process from time to time. Feel free to politely comment below. Please also do your own research before undertaking a project, and make sure to take proper safety precautions!*
That engine is why I bought a 1980 F150 short bed 6 years ago at an auction. 74,592 actual miles on it, garage kept.
The Ford 300 inline six cylinder engine has the best sound and fun to build
Nice job!
Nice 👍 I got one going into my 1979 bronco
Que buenos videos. Me ayudaron bastante igual estoy en la reconstrucción de la mía. Con ayuda del manual y tus vídeos se facilita mucho.
If you notice the original washers were a two piece design - a thick washer with a convex top and a thin washer with a concave bottom. The thin washer sat on top of the thick washer and was designed to provide even clamping force between two uneven surfaces.
Awsome job! I can't wait to watch the final results. Question for you on the pushrod length-- is there a way to know if your rods are too long before putting the head and rockers on?
I have same engine i remove the pistons but rings need to replace and cramshaft bearings shoulbe installed standar size all the parts back on ty
did he mention all the block and head machining costs, if they were done?
What lubricants and oils did you use?
Are all the lifters supposed to set flush when you drop them in? I see a few didn't go flush and a few of mine didn't fall flush either, wondering if that's normal.
What year is the motor ? I have the hydraulic lifters and its a different valve adjustment on it. My engine is a 77 do you know about the adjustment on them ? Thanks
Is there a way to put dual overhead cam on this Ford 300 Inline 6 Engine ?
What kind of pistons did you put in it ?
what about setting the lash on the valves?
Do you have a part number on those arp studs?
Is that the same as the 4.9