Cut stainless braided fuel lines

I can now cut and fit the braided stainless fuel lines. I transferred the mock up tubing measurements to the fuel line and cut them to fit. I am using a tubing cutter to get a good straight line on the braided line. The tubing cutter also compresses the steel braid filaments at the point of the cut and helps keep it from fraying. The Dremel tool also gives a good fray free cut to get the hose end on correctly.

[@stevet4064]

Good method, tks. for taking the time to make this.

[@overmarsdaria3222]

Switch of that tool for God sake !!! I could see one of your fingers off. Next time use a vice

[@emmanuelm1]

would that leave dust inside the hose? bad for the engine.

[@backyardbuild]

All fuel lines will be fully flushed out prior to installation.

[@chasintails2179]

You should wear some gloves bud... fingers don’t just come back

[@rickspa8348]

One slip and you’ll be changing your religion..!!