Komentáře •

  • @metriconejkt
    @metriconejkt Před rokem +1

    Good technique and skill full

  • @AmrinderSingh-zx9hr
    @AmrinderSingh-zx9hr Před 5 měsíci

    Great

  • @Leo021_02
    @Leo021_02 Před rokem

    Nice work

  • @masbinbengkel5396
    @masbinbengkel5396 Před 2 lety +1

    salam otomotif dari indonesia thank you my friend🇮🇩🙏

    • @Zimbiker
      @Zimbiker Před 2 lety

      Shukriya ❤️❤️

  • @nnvlog66
    @nnvlog66 Před 10 měsíci

    Piston ki digree kya the ye to apne bataya hi nahi sir❤

  • @duybeni3527
    @duybeni3527 Před rokem

    selam amazing

    • @Zimbiker
      @Zimbiker Před rokem

      Walaikum selam thanks ❤️

  • @yogaalvinaris9740
    @yogaalvinaris9740 Před 2 lety +1

    Mantap mas bro

  • @randyagbayani2947
    @randyagbayani2947 Před 2 lety +1

    If it’s already used piston, the outer diameter will not 100% fit to the cylinder block.

    • @Zimbiker
      @Zimbiker Před 2 lety +4

      I show only piston cutting method.
      We did not fit this piston in to cylinder block. We know.
      Thanks for watching 👍

    • @nabeelmunir7685
      @nabeelmunir7685 Před rokem

      @@Zimbiker OK Vere nice information sir give your shop address

    • @Leo021_02
      @Leo021_02 Před rokem +1

      Bro ya piston bhi use kia ja sakta hai but cylinder slip new dal kar....new cylinder laganay Mai expenses Kam parta hai.

  • @icarossavvides2641
    @icarossavvides2641 Před rokem

    Not quite sure what the point is? You've just reduced the compression ratio?

    • @k4spermlbb
      @k4spermlbb Před rokem

      they removed the dome so they can basically run a thinner base gasket or no base gasket (just liquid gasket) and so the piston wouldn't interfere with the head and i guess the deeper valve pockets were for higher duration or higher lift camshafts.

  • @MuhammadBilal-tl7bv
    @MuhammadBilal-tl7bv Před 2 lety +1

    Sir app ki shop kahan ha mujhe app ka kaam bohat passand aya pleas contact number