Today we install the dash cam in Rhiannon's car and get the bull bar sorted. Also have to refill Henry's water to keep him spraying. Im off on holiday so make sure you all stay safe!!!!
Be careful with that cable run across the door trim JH. You don't want the cable to strangle the curtain airbag so it can't deploy properly. If you remove A pillar trim you can run the cable behind the air bag so it can always deploy correctly.
Don't worry too much about the dash cam if the windscreen needs replacing as most repairs should have some replacement double sided tape to reattach the bracket
You had that ripcord around the wrong way the first time😅 Could you not mount the 4inch pump on the truck and use it to pull from both locations? I take it you have no ground water available?
Hi John just enquiring what breed of dash camera it is. Use some 222 Loctite to secure bolts as then you can get them undone easy and they won't rattle loose cheers hope this helps and have a good break away
Thanks for that. With the impeller on the pump, give it a few taps using a brass drift on the end of the shaft. It will help break it loose on the threads. Invest in a set of deep reach impact sockets, you'll use them more than any other socket as well for the removal of the impeller. Hope this helps.
Ask everyone to check whether their subscriptions are still active. We regularly get unsubscribed from our favourite channels 😮...even when we think we are subscribed!!!😮
Hi mate you need a bull bar with side rails down to your side steps You need to think about safety when you have family in the car Bugger the cost Have a look at tuff bull bars
Quality of the dash cam isn’t great JH, should have got a full HD/4K model, you’ll get number plates and company names then, and likely some footage for the channel..
I would agree. Unfortunately it was the only one available in Esperance at the time so I settled for the 2k. Haven't actually pulled the SD card out and checked the quality yet but it will be 1000 times better then the screen recording I showed but I agree not to the best standard that I could get
There should have been a competition for a hat on how many swear words yelled when trying to start the pump 😂😂😂
only a few....I swear!
Be careful with that cable run across the door trim JH. You don't want the cable to strangle the curtain airbag so it can't deploy properly. If you remove A pillar trim you can run the cable behind the air bag so it can always deploy correctly.
II put a tool box with sockets, wrenches , pliers, etc. in every vehicle. They are relatively cheap.
Don't worry too much about the dash cam if the windscreen needs replacing as most repairs should have some replacement double sided tape to reattach the bracket
Yer I did wonder what they did there! But there are so many dash cams getting around now that I assumed they had some trick up their sleeves!
Comment for the algorithm
Use Lock Tite. and lock nuts.
You had that ripcord around the wrong way the first time😅 Could you not mount the 4inch pump on the truck and use it to pull from both locations? I take it you have no ground water available?
Hi John just enquiring what breed of dash camera it is. Use some 222 Loctite to secure bolts as then you can get them undone easy and they won't rattle loose cheers hope this helps and have a good break away
It's a AUTOBACS EAGLE-I2.1K 2K QHD DASH CAMERA W GPS. But if you are getting one I would recommend a 4k one for best picture quality
Thanks for that. With the impeller on the pump, give it a few taps using a brass drift on the end of the shaft. It will help break it loose on the threads. Invest in a set of deep reach impact sockets, you'll use them more than any other socket as well for the removal of the impeller. Hope this helps.
Ask everyone to check whether their subscriptions are still active.
We regularly get unsubscribed from our favourite channels 😮...even when we think we are subscribed!!!😮
Hi mate you need a bull bar with side rails down to your side steps You need to think about safety when you have family in the car Bugger the cost Have a look at tuff bull bars
General question. Is Henry your brother in law ? I detect some NZ. Gra
No Henry is true blue New Zealander. First came to work for us in 2015 and then was working on an off till 2020 when he became a permeant
Quality of the dash cam isn’t great JH, should have got a full HD/4K model, you’ll get number plates and company names then, and likely some footage for the channel..
I would agree. Unfortunately it was the only one available in Esperance at the time so I settled for the 2k.
Haven't actually pulled the SD card out and checked the quality yet but it will be 1000 times better then the screen recording I showed but I agree not to the best standard that I could get