Stonemasonry - MAINSTONE CARVING - letter cutting boulder

In this short video I show the process of making a small boulder hole sign using a pneumatic hammer and finishing by hand with a hammer a chisel. I hope you enjoy!
Music: bensounds.com

[@TheJosepi87]

Hi Tom, that yellow box just inside your door, is that a 3 phase generator for your water walls?
The reason i ask is i am looking at getting a waterwall, although they do them in single and 3 phase the three phase ones are a lot more consistent so im told, but its very difficult to get reasonably priced workshop space with 3 phase power so was looking at generators.
cheers for the videos, not many masonry ones about that show the process.👍

[@mainstonecarving]

Hello,
No its not a 3 phase generator, its actually my screw compressor for my pneumatics. I have heard you can get single phase walls. its just a motor and a pump to run so it shouldn't be too hard to swap over. I haven't heard any reviews of them though.
are you uk based as I actually have a machine I don't need anymore. its 5 meters so its a bit of a large unit for one person but let me know if you may be interested. 👍

[@mattroberts9839]

Hiya mate whats the paper behind the paper with the lettering on ? Isit wet and dry ? Cheers

[@mainstonecarving]

Hello Matt,
No, its carbon paper. you can get it online or from most decent office supply places. Its got a ink side and a non ink side. Just put the ink side down and when you write over it with a ballpoint pen it transfers the lines through onto whats below.

[@mattroberts9839]

@@mainstonecarving thanks tom appreciate the reply top man 👍