Flight Problems with LYZRC L600 Pro Max (Part 2)

Sdílet
Vložit
  • čas přidán 27. 01. 2024
  • Flight Problems with LYZRC L600 Pro Max (Part 2)

Komentáře • 18

  • @emmanuelakinyemi1349
    @emmanuelakinyemi1349 Před 3 hodinami

    The obstacle avoidance is a problem

  • @nimrodbarda
    @nimrodbarda Před 4 měsíci +2

    Remove the obstacle avoidance

  • @erwinevangelista1453
    @erwinevangelista1453 Před 4 měsíci +1

    I have L600 pro max its very stable to flight use mode1

  • @lemamado8219
    @lemamado8219 Před 5 měsíci +1

    If you use the obstacle avoidance try to put the controller in mode 2..

    • @WestLondon1
      @WestLondon1  Před 5 měsíci

      Thank you for the tip. However, the obstacle avoider isn't the main problem (though it doesn't appear to function correctly) but the bigger worry is the wandering drone that has a mind of its own! :)

  • @maxandredeloso9538
    @maxandredeloso9538 Před 22 dny

    So weird question can i swap my l600 pros camra and gimbal module with the l600 pro maxes?

  • @rcjmgaming3812
    @rcjmgaming3812 Před 5 měsíci +1

    bro I think you should replace the propeller and recalibrate the drone again if it works, and if not, maybe try switch the gps to optical flow mode if it flies stable

    • @rcjmgaming3812
      @rcjmgaming3812 Před 5 měsíci +1

      But i don't recommend the optical flow for long range flight, its just a guess if the gps is the main problem or the chip board inside of the drone

    • @WestLondon1
      @WestLondon1  Před 5 měsíci +1

      Thank you brother - really appreciate the advice. Can't risk switching off the GPS in case it decides to fly off on its own which it has done on a couple of occasions already....lucky (and was luck more than skill!!) managed to bring it down and grab it by hand. I've had the drone for less than a month and has been like this since I got it out of the box....one of the batteries supplied also doesn't latch so can't even use it for fear of it falling out mid flight! Have contacted banggood.com (where I purchased it from) and they've been as helpful as a chocolate teapot despite offering a quality guarantee....making excuse after excuse and even suggesting I get it repaired myself and then giving them the invoice to see if maybe they will pay for the repair....
      Thank you once again and will be sure to keep everyone posted!

  • @gotzolones
    @gotzolones Před 5 měsíci +1

    You have calibrated the LYZRC L600 PRO Max drone..?

    • @WestLondon1
      @WestLondon1  Před 5 měsíci +2

      Hi @gotzolones - yes, I fully calibrate before every take off (3-4 spins horizontally followed by 3-4 spins vertically until you hear the beep sound). I also wait until there is a minimum of 8-10 satellites so GPS (should be) fully locked. The drift on this is terrible and shouldn’t be this way at all.

    • @jsmattos88
      @jsmattos88 Před 5 měsíci

      O meu L600 pro Max está fazendo isso também, estou com medo até de subir ele mais alto e ele dar uma de voar sozinho.

    • @gotzolones
      @gotzolones Před 5 měsíci

      @@jsmattos88

    • @gotzolones
      @gotzolones Před 5 měsíci

      @@jsmattos88 Eu ia comprar uma L600 Max e vendo essas deficiências decidi há uma semana não comprar. No final, com um pouco mais, comprei um Mavic mini usado.
      Você terá que reclamar a garantia de fábrica, produto ou seguro da compra ou da casa do drone porque não é normal ele fazer essas coisas.

  • @cartfredo4782
    @cartfredo4782 Před 9 dny

    Maybe the chinese controling it and spying on you 😅

  • @slavchez
    @slavchez Před 2 měsíci

    Clean the optical flow sensor on the bottom of the drone and disable Obstacle avoidance. The Obstacle avoidance of those cheap drones is terrible. Do NOT use it. Ever.