ABA Block MK2 8v Head Engine Assembly
Vložit
- čas přidán 30. 04. 2018
- Here's how to assemble the MK2/MK3 hybrid engine and install all the extra parts needed to run a MK3 ABA bottom end with a MK2 head.
Previos video - • ABA & 1.8 8V Engine Te...
Next video - • ABA MK2/MK3 Hybrid Eng...
Techtonics parts list -www.techtonicstuning.com/ABA_E...
NOT A SPONSERED VIDEO
New videos every Tuesday! - Jak na to + styl
great video just wish the camera wasnt so fuggy
Great Job! Make sure to replace the crank gear with a New One! There is a Male protrusion on it, a Female slot on crank, not a Woodruff key. My crank gear Male protrusion was Gone! And it will damage Female slot on crank. Only $12 eBay. Should be done every belt change, stupid design. Also, go to local paint shop, buy some Por15, or equivalent. Will do great job as block paint, and can brush on. I like to use Wrinkle paint, aka old hemi head valve cover paint. Keep the vids coming!😀
genius timing tool
I have a couple questions. Why can't you just use the distributor and intermediate shaft that came with the 2l?
I would have kept the oil cooler that was above the oil filter it helps the life of the engine.
Nice job looks good thinking about doing this swap I know this is a stupid question but I need to know can I still use the same trans clutch and all that after the swap nothing I needed and changed there correct
same clutch will be fine, I didn't change mine
Why didn’t he use the impact gun at the beginning when taking the flywheel off?
It's actually not a very good impact gun at all and didn't have enough torque