Turboprop Engine Gauges Explained! Pilots and Aviation

Sdílet
Vložit
  • čas přidán 21. 06. 2024

Komentáře • 16

  • @kam1583
    @kam1583 Před měsícem +4

    Thank you, as a pilot flying a 65 hp aeronca7ac, that was educational 😊

  • @Nervrom
    @Nervrom Před měsícem +8

    That’s pretty cool. Dont know how pilots look at all of Howe plus more during takeoff and stuff

    • @user-on8lp5zx5k
      @user-on8lp5zx5k Před měsícem

      You are looking at relative needle positions and differences to what you expect to see. It’s easy when there is a big difference in needle position to “spot the difference”. You also typically set an intermediate takeoff power against brakes, check, set takeoff torque then have a quick scan again.

  • @d.sparkes346
    @d.sparkes346 Před měsícem +3

    Very cool.
    When I was a kid, I wanted to be a pilot, and as an adult it’s on the list when I hopefully get to retire lol.

    • @yamkaw346
      @yamkaw346 Před měsícem +1

      Make it happen, lots of pilots make the career change to aviation from 35-50 years old

  • @crazypilot4017
    @crazypilot4017 Před měsícem

    Nice 👍

  • @dasdguy7606
    @dasdguy7606 Před měsícem

    Cool Man. Thanks for the breakdown.

  • @phillipbutler8451
    @phillipbutler8451 Před měsícem

    Nice work

  • @michealnwadobu7344
    @michealnwadobu7344 Před měsícem

    Sweeeet now I know what they monitor.

  • @danzaeske6514
    @danzaeske6514 Před měsícem

    Thanks! I never knew what Ang’s are

  • @glennwatson
    @glennwatson Před měsícem

    how's it compare to a piston based CSU aircraft? Do you change your pitch much?

  • @husky9088
    @husky9088 Před 12 dny

    :)

  • @tomlovinggood265
    @tomlovinggood265 Před měsícem

    What does NG refer to?

    • @KevinMaloney01
      @KevinMaloney01 Před měsícem

      N is typically a common letter to represent speed. The G stands for gas generator or gas turbine speed, also known as a power turbine in turbo shaft engines. It represents how fast the power turbine and power turbine shaft is spinning. The power turbine is connected Via a shaft going to the gearbox on the front of the PT6 engines. If you didn’t have the gearbox the blades could potentially have a catastrophic failure and or simply disintegrate.

  • @nervouswreck392
    @nervouswreck392 Před 19 dny +1

    An fuel gauge should be the 1st one‼️ ya✔️... Read more

  • @TheMike31b
    @TheMike31b Před měsícem

    Sus