Installing a Switch Panel Battery Isolator | TINNY BUILD SERIES EP4
Vložit
- čas přidán 22. 08. 2024
- In this video we install a Relaxn Switch Panel, Isolator Switch and Buss Bar on the Outback Equipment tinny. Rob runs us through step by step how to wire up your 12v battery system right at home. The products we used are:
Buss Bar - www.outbackequ...
Isolator Switch - www.outbackequ...
Switch Panel - www.outbackequ...
Water Proof Mount - www.outbackequ...
We were stoked on the functionality and ease of install. A switch panel is a great way to add extra lights, devices and pumps to any small trailer boat. To check out our range of boat electronics head to the marine category on our website: www.outbackequ...
We also sell a wide range of 4x4 and camping accessories, with more being produced shortly to keep up with demand so for more information on 4X4 accessories, marine, caravanning & outdoors check out our website:
- www.outbackequ...
If you do have any questions about this product, get in touch with our experienced customer service team at service@outbackequipment.com.au
#boats #tinnybuild #marine #installvideo #productreview #switchpanel #12vbatterysystem
Great video. As a complete beginner to 12v, it is something that is somewhat difficult to find to the point instructional videos like this. Thank you for making it simple.
Glad it was helpful!
Good vid. Something I wish you'd emphasised was that when you're pushing on the flexible conduit that it MUST pass through the hole you drilled in the aluminium storage. If the wires are just passing through the hole in the metal and then entering the conduit the vibrations will short them out in no time. While on the topic, you really ought to put an inline fuse or circuit breaker in the positive line as close as practical to the battery too.
Agree completely....thats a long length of positive wire which isn't fused. This is dangerous.
Wow, just woke, thanks for the knowledge mate! Can you send a link for the next video? Can’t find it in your playlist.
Nice video, I like the way you connected the battery to the panel switch. I will be using a fuse block instead of the buss bar. Just like you I am using the battery box and mounting the shutoff on that box. I do have a question, how you are going to connect the key switch and the outboard to the battery.
HI Anthony, our Motor is just a manual start "pull cord" so we didn't have to worry too much about that when connecting our outboard to the battery. If you were to have an electric start same thing applies to installing anything to the battery. Positive to the switch and Neg to the battery. It would be slightly different again if you were to have dual battery system.
Hi, thanks for all the great info, what connector did you use to extend the black neg wire from panel going back to battery, or did you solder it?
Is all the wiring you used 4mm twin core? Thanks
Excellent video, well done. Can you please supply details of which battery box you used and the gauge of wire for each application.
Hi Chris, here's a link to the battery box we used- www.outbackequipment.com.au/battery-box-standard and in terms of wire, we used 4mm twin core sheath tinned wiring.
@@OutbackEquipment Hi guys, thanks very much for the info and timely reply.
You must install an inline fuse as CLOSE as possible to the battery ie between battery terminal and battery switch. What happens if you get a short in the circuit before the inline fuses you have on the switch panel ?
Any reason why no negative bus bar? Do you have all accessory negatives running to the battery?
Yes all negs are back to the battery. I'm going to go with a neg bus bar instead.
Do not use automotive connectors in a marine environment. They will not last long.