I just did both tires and tubes ( ulip tires 2 tires and tubes 59.99...they ride nice. I tested them for 10 miles and pre slimed them) on my varla eagle one. It took about 3 hrs. I took my time. If any screws on the discs wont budge heat them a little very carefully w a lighter or small torch and they will pop...also its VERY IMPORTANT to use quality hardened steel allen wrenches and be sure they are seated well before loosening and tightening. I took pics of how the spacers are etc...do your homework and you can do this job....labor on scooters is like 99 bucks an hour at a good shop so i saved mad loot....
What size screw driver to take off the cap thats on the wheel. Is it also possible to get a list and size of each tool? My bad im new to repairing my scooter
the caps just pop off they are not held on by anything. You don't need much more then a standard metric Allen wrench set. A 21 mm socket. Its a lot easier then you think. Take your time work slow and think each move out and you will be done in no time.
I looked for a decent set but haven't found one I would prefer over the air up style. I also like the ability to change the tire pressure depending on the environment.
I got 1600 miles out of original tires. The front was bad from spinning all the time the rear still had at least 500 to go...so 2000 miles on a set of tires is good? Not one single flat...I'm pretty lucky but take the same routes so familiar w the road bullshit
I just did both tires and tubes ( ulip tires 2 tires and tubes 59.99...they ride nice. I tested them for 10 miles and pre slimed them) on my varla eagle one. It took about 3 hrs. I took my time. If any screws on the discs wont budge heat them a little very carefully w a lighter or small torch and they will pop...also its VERY IMPORTANT to use quality hardened steel allen wrenches and be sure they are seated well before loosening and tightening. I took pics of how the spacers are etc...do your homework and you can do this job....labor on scooters is like 99 bucks an hour at a good shop so i saved mad loot....
Did you re-apply loctite to the disc screws or no?
What size screw driver to take off the cap thats on the wheel. Is it also possible to get a list and size of each tool? My bad im new to repairing my scooter
the caps just pop off they are not held on by anything. You don't need much more then a standard metric Allen wrench set. A 21 mm socket. Its a lot easier then you think. Take your time work slow and think each move out and you will be done in no time.
@@WorkingClassINC will regular 21mm wrench work?
Have you ever switched to solid tires?
I looked for a decent set but haven't found one I would prefer over the air up style. I also like the ability to change the tire pressure depending on the environment.
I got 1600 miles out of original tires. The front was bad from spinning all the time the rear still had at least 500 to go...so 2000 miles on a set of tires is good? Not one single flat...I'm pretty lucky but take the same routes so familiar w the road bullshit