How To Sand Out A Run Successfully

Sdílet
Vložit

Komentáře • 7

  • @austinthebeast33
    @austinthebeast33 Před měsícem

    That’s an okay method . I prefer to spray a UV primer over the run and just reapply if it starts to disappear too much while blocking . Much lower film build and easier to get off when blocking with the finer grits

  • @chrisoo8998
    @chrisoo8998 Před měsícem

    Ohh jeez i hate runs my worst nightmare

  • @theinsaneshecklador6598
    @theinsaneshecklador6598 Před měsícem

    Is there a reason you don't shave the run down a bit with a razor prior to the glaze? Wouldn't that cause less sanding?

    • @markdrewett149
      @markdrewett149 Před měsícem

      yes

    • @linearblockingtools4064
      @linearblockingtools4064  Před měsícem +1

      Typically yes but this one wasn’t real tall I tried and it wouldave been dangerous lol

    • @theinsaneshecklador6598
      @theinsaneshecklador6598 Před měsícem

      @@linearblockingtools4064 Thank you for the explanation.

    • @markdrewett149
      @markdrewett149 Před měsícem

      @@linearblockingtools4064 at the end of the day its an awesome job. I just bought my first set of L blocks and cant wait to try. I have left the final 600 until they got here.