For safety reasons. This way nothing can fall down on their toes and cut them off. But i don't know the clue behind it why they also never uses toilet bowles.
Another reason is the floor doesn't wobble and can withstand heavy hammer blows etc. There are many reasons why you would do stuff on the floor if you don't have a very expensive steel monolith table
Very technical work to perform without a manual of any kind. Kudos to them for sharing this video. 😁👍🇺🇸
Fantastic job.
After repair all tolerances are guaranteed less then 2 fingers.
Motor redutor de Hitachi 200
Don't forget the hand full of sand after the assembly.
Good job 💯
Cómo reparar un redutor
why did they all work in the dirt on the floor and not at clean table????
Work on table after finish job must clean table but work on floor not clean anything 😁😉
For safety reasons.
This way nothing can fall down on their toes and cut them off.
But i don't know the clue behind it why they also never uses toilet bowles.
Another reason is the floor doesn't wobble and can withstand heavy hammer blows etc. There are many reasons why you would do stuff on the floor if you don't have a very expensive steel monolith table
Making do with what you have.
I see somethings that shouldn't be but I'll just say hmmm.