if there is a small gap between the inner fiber layer and the analox body on one end how can it be re-glued.... is this small gap affect much o the quality of printing i appreciate much your reply
How could we use stainless steel brush which is a hard material i believe that could scratch rolls. What kind of steel brush do you recommend could you pm a link. Is it possible to use high pressure "120- 150 bar for car cleaning" water jet to clean anilox rolls.
steel is hard enough to remove ink and contaminants from the anilox cells, but is soft enough to not wear out the ceramic structure of the anilox surface
I am surprised that this video does not encourage the use of roll covers to reduce impact damage. If interested in reducing the amount of impact damage to your rolls, contact either Pamarco or Andy's Roll Covers.
Thank you for the valuable training session
if there is a small gap between the inner fiber layer and the analox body on one end how can it be re-glued.... is this small gap affect much o the quality of printing
i appreciate much your reply
Very good effort - pls continue sharing knowldge
what is the life time of anilox normaly
How could we use stainless steel brush which is a hard material i believe that could scratch rolls. What kind of steel brush do you recommend could you pm a link. Is it possible to use high pressure "120- 150 bar for car cleaning" water jet to clean anilox rolls.
Why only steel brushes mentioned?
steel is hard enough to remove ink and contaminants from the anilox cells, but is soft enough to not wear out the ceramic structure of the anilox surface
Interesting
Surface tecnology praxer...
I am surprised that this video does not encourage the use of roll covers to reduce impact damage. If interested in reducing the amount of impact damage to your rolls, contact either Pamarco or Andy's Roll Covers.
You mean while anilox isn't in use correct?
@@treyferguson2965 Yes, while in transport, storage, and moving to and from the press.