Thanks for great video. Even though I didn't have the same grill as you, (I have the PB700FB), it was really close. I didn't have to remove the pellet bin. The screws and nuts to hold probe in place were a little difficult to get to with my fat hands. I did have to remove the control panel, as mine does not have the plug. Mine has two tiny screws that connect the wires to the circuit board. Either you keep your grill very clean, or its really new to be having to change that out already. Thanks again!
Thanks for great video. Even though I didn't have the same grill as you, (I have the PB700FB), it was really close. I didn't have to remove the pellet bin. The screws and nuts to hold probe in place were a little difficult to get to with my fat hands. I did have to remove the control panel, as mine does not have the plug. Mine has two tiny screws that connect the wires to the circuit board.
Either you keep your grill very clean, or its really new to be having to change that out already. Thanks again!
I keep getting an “ERL” code on my pitboss and noticed the temp always stays at 50F. Im pretty sure this is the problem. Thanks for the video!
I have been never seen and old videos with no comments lol