PWNCNC Dust Boot Assembly | Onefinity Elite Foreman
Vložit
- čas přidán 27. 08. 2024
- I purchased my first CNC the Onefinity Elite Foreman CNC. This is a step by step video of me setting up my PWNCNC V10 Dust Boot.
@OnefinityCNC @PwnCNC
I am by no means a CNC expert. Take what I do as a general guide and use at your own discretion.
Working with wood and power tools is inherently dangerous. Anyone using any of the tools or supplies used in these videos are personally responsible for learning the proper techniques involved, and he or she assumes all risks and accepts complete responsibility for any and all damages and injury of any kind.
Before using any hand or power tool with which you are unfamiliar, consult its operating instructions, and if necessary, seek instruction by a qualified person well versed in its operation and appropriate safety techniques.
Pleasant Woodworks is intended for entertainment purposes only. There are no warranties implied and your results may differ from ours. You should NOT rely solely upon the information and techniques discussed and displayed in these videos. Rather, you should fully research each technique and decide for yourself what is the safest possible work method for you.
You do a fantastic job filming the assembly content. However your getting the shots of things in front of you while you're working on them is great. Most people have it off at one side. That first person view or whatever you'd call it is amazing.
I appreciate it. I try to make content for the beginner and want them to see what I see every step of the way. Thank you.
Are you pleased with the air cooled spindle? Also did the vac / spindle switch come with your spindle? Excellent video
So far I’m pretty satisfied with my spindle. The black power switch didn’t come with the kit. I had to order that separately along with the white wire. Both are on their website. Thanks for the comment.
@@Pleasant_Woodworkscan u post the name/link of the power strip u used for the dust collector to vfd?
The the IOT power strip and IOT wire from PWNCNC.
Alright, subbed
I appreciate it.
I just go back online, so I'm sorry my responce was so late. I VERY much appreciate you candid feedback. I too wondered about the black power switch stange it's not included in the kit. Thank you again!!! All the best- Mick. Oh, and Yes I subscribed too!!!
No problem Mick. Appreciate the sub.
So what is it like changing bits? It looks like it might be a little hard to get to? I ordered up one before I thought of that. Mine arrives with my spindle kit tomorrow.
Not hard at all. I just finished a video going over the tool setter and touch probe and I show changing the bit. I just have to edit it. I just pull off the dust brush, change the bit, and put the brushes back. Thank you for the comment and have fun with your spindle!