Top FN PS90 Upgrade: Sure Cycle Alloy Magazine Rollers
Vložit
- čas přidán 22. 07. 2024
- Inexpensive. Reliable. Easy to install. Can you get any better than that? Check them out below, and don't forget to hit that subscribe button!
Sure Cycle Rollers
www.midwestgunworks.com/page/...
All information provided is merely for entertainment and informational purposes. Should you decide to act upon any information provided, you do so at your own risk. Midwest Gun Works does not accept any liability for any mistakes, errors, or faults that may occur. Refer to the manufacturer for specifications of the products used. It is recommended that all modifications or repairs be done by a qualified Gunsmith. - Sport
I installed these in my magazines… really smooths out the loading and has cycled my ammo flawlessly. Highly recommended.
Alloy rollers came in today know I’m installing them ❤
I put DELRIN rollers in all my PS90 magazines. Works great.
**There is one (unlikely) scenario where Delrin rollers would be better than aluminum rollers and that is in a situation where the P90/PS90 was in a damp, warm room and immediately taken outside to a really cold (say -10 F.) environment. There the moisture on the aluminum rollers would quickly freeze and possibly cause a stoppage. Delrin's surface would not hold the moisture nearly as much.
I just purchased a six pack! ❤
I'm getting ready to add mine to 3 clips. I hope they work cause the other way. Is a pain in the butt.
Okay that was a P90 at the beginning, let me put my PS90 back in the safe 🥺
The factory rollers are molded. Machined Delrin rollers are aftermarket.
When putting that magazine back together, i would suggest to simply lay the mag on the table, put the rollers inside the mag, just past its edge, and than push them with the fallower all the way to the helical feedramps. Why fiddle with them, when the fallower, by design, will push them where they should go?
I didn't know you could smack the mags to unload them....
@ $40+ each, I'd be nervous about banging those mags that hard.
Do these fit/work in the promag p90 magazines that come standard with the keltec p50?
Yes they should!
Yes they do
Very similar magazines and the rollers can be exchanged between them. I see no reason these wouldn’t work for either.
Seems like whoever makes these could make a chunk of change selling pre-made mags with this mod ;-)
Thxs great video..where can I buy those Rollers?
We have them available on our website, P90ROLLERS
I found a used PS90 in a pawn shop, they have marked it down to $1,299.00 but I know they will take less, good buy?
You can find brand new ones at online retailers for $1299. I bought a RIA LE model that came with a 50rd mag for that much off Locked & Loaded, though there are a few others with the same price point
How can I make my p s ninety for auto
Shhhh! Brandon's buddy Beto may be watching you---
Is this a solution to a problem that actually exists or just something to address a made-up problem? P90 has been in reputable service for decades now with (as far as I know) OEM magazines. Not being facetious or anything, just curious...
My original mags work without any issues, but I have some aftermarket ones that just will not work, I want to try these and see if maybe that helps.
@@morrokbyo Everything I read says to stick to real FN mags. The after-markets may be cheaper, but they tend to be a POS.