KTM 390 Adventure | removed resonator box, exhaust component from Ali

Sdílet
Vložit
  • čas přidán 28. 08. 2024
  • removed resonator box from exhaust system
    exhaust component: m.aliexpress.c...

Komentáře • 56

  • @AlexandruGaal
    @AlexandruGaal Před 6 měsíci

    Nice video showing the procedure.
    It's one of the best upgrades for the Ktm 390 Adventure

  • @wfodavid
    @wfodavid Před 6 měsíci

    I did the same but also punched out the cat. sounds nice not too loud and actually runs fine.

  • @micro_cuts2832
    @micro_cuts2832 Před rokem +2

    I bought the same one, a little bit loud but not to much, in 4000km i didnt have any trouble with police, i have shorts in my account for those who are curious of how it sounds attached and warmed up

  • @PedroMurilloChaves
    @PedroMurilloChaves Před 4 měsíci

    Hello. Excellent video.
    Have you noticed any increase or decrease in fuel consumption after this modification?
    Greetings from Costa Rica 🇨🇷

  • @pakit0400
    @pakit0400 Před rokem +1

    I did the same process as in your video, but there is a smell of smoke, but everything is well sealed, I have the following doubt: does there have a gasket or plastic between the engine and the exhaust pipe? Because there was none in mine plastic

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před rokem

      Hi, tighten the lead on the engine head to 20NM.
      For the rest, I used exhaust mounting paste, as in the video.

  • @pjmac71
    @pjmac71 Před měsícem

    What was the goop used at the attachment ?

  • @19Ander86
    @19Ander86 Před 5 měsíci

    Dobrý den, také jsem odstranil rezonátor. Zaznamenal jste prosím nějaký rozdíl ve spotřebě? Nyní jezdím za 3,8 L dříve při stejném jízdním stylu tak o tři deci méně. Nainstaloval jsem ale také FuelX. Průběh motoru je lepší, ale spotřeba je stále i něco vyšší než s origo rezonátorem. Mám model 2022. U mě řezat nebylo třeba, ale objednával jsem trošku jinde na AliExpress, byť díl vypadá skoro stejně. Díky za inspiraci. Zvuk je nyní jako s laděným výfukem.

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před 5 měsíci

      Dobry den, ja som hned v jazde spozoroval lepsi zatah v nizsich otackach, samozrejme aj hlucnejsi zvuk vyfuku co mi samozrejme neprekaza. Co sa tyka spotreby tak tam nevidim rozdiel, okresky 3 - 3,5l a dialnica presuny mi obcas vybehne aj 4,5l

    • @19Ander86
      @19Ander86 Před 5 měsíci

      @@jaroslavmihalco6708 Díky moc za odezvu. Určitě je to tak lepší, nějakou váhu to taky ušetřilo navíc zadní tlumič teď není namáhán teplem. Určitě mrkněte na ten FuelX. Nově má zastoupení pro Evropu ve Španělsku, přišlo to do týdne, přidá to taky nějaký zátah od spodního pásma. Já plánuji ještě nějaký filtr sportovní, možná úpravu Airboxu. S pozdravem Tomáš.

  • @davemlnr
    @davemlnr Před 4 měsíci

    Nazdar, vo videu ten dolný srôb ako si dal von čo drží rezonátor, lebo mňe to naráža do držiaku stupačky?

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před 4 měsíci

      Ked sa sruba povytiahla. Podarilo sa mi ju dostat do takeho uhla, ze sa vysunula cela a nevadil uz drziak stupacky. Najlepsie je odmontovat aj zvod z hlavy motora a demontovat to cele naraz, ako len samotny rezonator.

  • @talhagunes91
    @talhagunes91 Před 3 měsíci

    Hi! Did you manage to fit the cat gasket in? I think I see it on the video, but I was unable to fit the midpipe with the gasket. It is a snug fit without it. Thanks for the video.

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před 2 měsíci

      Hi, not if you mean bigger gasket. I used sealing blow paste

    • @talhagunes91
      @talhagunes91 Před 2 měsíci

      @@jaroslavmihalco6708 at czcams.com/video/fI06kleM5o0/video.html you are applying paste not on the original gasket then. The color of that part is same as the gasket with that lightning. Additinonally, if you use spacers and position your midpipe through the middle while tightening, you will have less noise at high rpm range.

  • @WOSBiker
    @WOSBiker Před rokem

    Nice video. I also have a KTM 390 Adv. I am very happy with it. What is it and where do you get the “filter” you put inside the new exhaust pipe. Thank you

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před rokem

      Hi, what filter do you mean?

    • @WOSBiker
      @WOSBiker Před rokem

      @@jaroslavmihalco6708 At minute 3:30 you can see a part inside the exhaust pipe.

    • @AlexandruGaal
      @AlexandruGaal Před 6 měsíci

      @@WOSBikerthat one is the 2nd catalytic converter (not a filter, it burns unburnt fuel).
      theoretycally it's ileagel in most countries to remove it, or to drill it.

  • @alonzoanaya6424
    @alonzoanaya6424 Před 7 měsíci

    Tanks a lot, please could you explain to me about the 3mm cut, was it necessary to do it? 2:33

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před 6 měsíci

      The exhaust parts would not touch each other.
      There would be a gap at the ALI exhaust elbow joint.
      -possible leakage,
      -leakage of exhaust gases

  • @stuartreddiex
    @stuartreddiex Před měsícem

    Have you got the link for this exhaust on Ali?

  • @deoptographer923
    @deoptographer923 Před rokem

    Brois their any problem after fixing this

  • @irideaz390
    @irideaz390 Před rokem

    Nice video! What is the weight savings? Performance improvement? Also what is that blue thing on the exhaust?

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před rokem

      Thank you. Weight saving is possible 2kg. The blue thing is a minimalist protector from Ali

    • @19Ander86
      @19Ander86 Před rokem

      Ahoj. Zaznamenali jste nějaké výrazné změny ve zvuku a průběhu výkonu? Dík.

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před rokem

      @@19Ander86 Ahoj, lahsie sa rozbieha z nizsich otaciek. Zvuk je hlbsi, ale zase nijak nevadi pri vacsich presunoch

    • @19Ander86
      @19Ander86 Před rokem

      Super, díky za inspiraci. Uvažuji, že bych do toho po záruce šel.

  • @juanicoct1
    @juanicoct1 Před 6 měsíci

    is 100% necesary cut the 3 mm?

    • @19Ander86
      @19Ander86 Před 5 měsíci

      I did the same removal and it wasn't.

  • @teddybowker7309
    @teddybowker7309 Před rokem +1

    This is not a cat delete ??

  • @packfan1946
    @packfan1946 Před rokem

    Where did you get the upper crash bar????

  • @xy404
    @xy404 Před 7 měsíci

    what is that paste you are putting in there ?

    • @jaroslavmihalco6708
      @jaroslavmihalco6708  Před 6 měsíci

      it is a standard high temperature paste for sealing exhaust joints

  • @deoptographer923
    @deoptographer923 Před rokem

    Is their any engine or pollution issue with this after installing

    • @abominacja47
      @abominacja47 Před rokem +1

      Only noise pollution :) Resonator box is designed to cancel out sound waves so the bike is quieter, therefore Euro compliant. Also, since there's less back pressure it may reduce cat efficiency and bike may run hotter since it's already lean on mixture. I would install it along with new fuel mapping just to be safe.

  • @rossi9209
    @rossi9209 Před rokem

    Do i lose my warranty if i change to a full exhaust ? I got The 2022 model

  • @deoptographer923
    @deoptographer923 Před rokem

    Bro i also do the same but it seems very louder how can we reduce the sound

  • @demonsync57
    @demonsync57 Před rokem

    So, to remove the resonator... you cut to the part where you have spent some time and now there are 2 persons there.. ok.. now i see i have to unscrew a lot of things

  • @avib3799
    @avib3799 Před rokem

    Did you notice a change in the sound?

  • @ervingaming9890
    @ervingaming9890 Před rokem

    👍New subscribe.

  • @ghora43
    @ghora43 Před rokem

    is it catalyst inside?

  • @johnjohansson4118
    @johnjohansson4118 Před rokem

    You removed the resonator box not the cat