Thank you so much! With your video I was able to draw the bevel gears which I going to buy based on the sizes provided in the aliexpress site and it is works!
thank you sir for making this video this will help me out ... i have some doubt about one problem sir its been little bit difficult me for finding their parameters 1.Design and model a Geartrain with following constraints: ●Driven and Driving shafts axes are perpendicular to each other. ●90 RPM is needed at the output shaft if the actuating motor is rotating 3/4th revolution per second. ●Module = 2 , pressure angle = 20 degree. ●No. of teeth on driven gear is 25. Show calculation how you got design parameters of gear. Create an assembly in solidworks, showing a working model of your design with proper mate and no interference.
When I drag and drop the gear into the workspace, it doesn't open the "Configure component" menu that comes up for you, so I can't edit the module and number of teeth. Do you know why this might be happening?
I want to attach a disk and want it to rotate it with pinion but its not happening. Actually i made a mechanical counter and want to attach that assembly at the side of this pinion, but counter's disk is not rotating with the pinion. Although pinion and gear were rotating. Can you help me with this one, please.
Thank you so much! With your video I was able to draw the bevel gears which I going to buy based on the sizes provided in the aliexpress site and it is works!
very useful video good
thank you sir for making this video this will help me out ...
i have some doubt about one problem sir its been little bit difficult me for finding their parameters
1.Design and model a Geartrain with following constraints:
●Driven and Driving shafts axes are perpendicular to each other.
●90 RPM is needed at the output shaft if the actuating motor is rotating 3/4th revolution per second.
●Module = 2 , pressure angle = 20 degree.
●No. of teeth on driven gear is 25.
Show calculation how you got design parameters of gear.
Create an assembly in solidworks, showing a working model of your design with proper mate and no interference.
Good video, thank you so much
איזה אח!!!!!!!
Very useful video..
Thanks a lot
thank you for you effort. But go to solidworks tutorial channel and learn the correct way. in reality u dont have sketches to show
Tnx
Very good video thank you. Would you be able to do one for designing gears for 3d printing ? Including clearances? Thanks again
How do draw sketch..? You didn't show that?
When I drag and drop the gear into the workspace, it doesn't open the "Configure component" menu that comes up for you, so I can't edit the module and number of teeth. Do you know why this might be happening?
I want to attach a disk and want it to rotate it with pinion but its not happening. Actually i made a mechanical counter and want to attach that assembly at the side of this pinion, but counter's disk is not rotating with the pinion. Although pinion and gear were rotating. Can you help me with this one, please.
hii,. what is module in bevelgear? i mean, what dimension is it? thanks
Sir how to cut one complite teeth from it, please help me ....
Can I import this on ANSYS and do the analysis?
my solidworks keeps crashing on basic motion calculation
Sir how to put shaft key in the hole
use mate command in assembly
pitch diameter?