Worlds Best Turbo Flutter! We Broke The Turbo.. Testing Your Dose Pipe Suggestions on the VL Turbo!
Vložit
- čas přidán 11. 09. 2024
- The VL Turbo Dose Pipe Testing is back!! We take your dose pipe suggestions and try to make the best dose possible with our VL Turbo! Lets see what makes the best Turbo Flutter possible!
Don't miss out on the pre-order!! - www.keepitreet...
It is easy to make your Turbo Dose if you have the right setup, especially if its a VL Turbo! A Dose can be referred to as Turbo Flutter or Turbo Surge, they are all the same thing. Ever wanted to learn how to make your turbo flutter? This is part 2 of our turbo flutter testing!
And to those that saw turbo flutter is bad for your turbo, your wrong! Because we said so..
Enjoy!
#KeepitReet
Head to Keepitreet.com for more Info / Merch / Stickers / Giveaways
Use Code "SPICEY" for 10% off our Merch
Support the channel and become a Member here for only $3
/ @keepitreet
where's the milo tin?
If there's one thing this suby guy knows, it's how to get that rumble. Need to section off the horns in the middle 4in connection, then make one side longer and have them come back together into 1 connector at the end.
The sound wave reverb oscillates along the pipe at a ratio directly proportional to the diameter and length. SCIENCE!
i dont understand ur comment but yeah, science
& material.
honestly if you made 100 of these videos i would watch every single one
25:30 is the best sound in the world ❤❤❤❤❤❤❤
22:03 killed me 🤣
7:29 when the build up to dose just hits different
Ever thought about trying a Fleshlight? I'm sure you fella's would have a few well used units kicking around.
Part 2 was as good as the first. I could watch dose science all day!
How about a two-stroke bike expansion chamber? Or a pair of didgeridoos, one on each end of the moose knuckle antler horns? (since a single didgeridoo was too restrictive)
Also a 3" cannon muffler, or a resonator?
Or the most extreme, a tea kettle? Maybe it would need to be cut a bit to not choke the engine.
That prank will never get old 😂😂👌🏻 poor TJ. Another great bit of science
Praangles and pvc pipes were my favorites. You should try do 3.5 inch pvc pipe see if you can get even more perfected, and some of that flexy plastic intake pipe aswell
Cheap alternative for the poor VL owners out there 😂
They should try a 225 6m length of pipe, that would be legendary
they should do a fart can lmao
Corey just that one guy always workin while the boys are muckin around. Keep up the good work cooooooreyyyy
You need to increase the volume of the intercooler piping after the turbo to slow down the pulse frequency. For shits and giggles, make a really long pipe or add a tank.
Get another VL turbo and do a 2 into one double dose pipe. Both VLs into a 3.5” stainless pipe would be insane if you could get them to dose together
😬😂 That sounds like a firing squad for a turbo or two
That double exit was best so far !! Great video guys as always !
what about a expansion chamber, kinda like a hotdog muffler that has no baffling in it
dosed my xr for 8 solid years 250,000km on stock turbo and it was still fine when I sold it. Dosing does not damage the turbo and or seals as other suggested. At least in my experience.
Traffic cone boys
2 things i would like to see is a resonator, and a killer glass tube. Normally used as a see-through radiator hose.
The pvc pipe sounded kaaaang.. Idea for nek time a actual trumpet! And get jessie boi to play different keys to see if it changes the dose… ooooft
Use a 3" stainless tube welded into a spiral or like a spring
use a muffler or resonator for the intake next time
Keen to see the difference in a large volume between turbo and throttle body and small volume. Eg: long cooler piping with front mount vs short pipe-turbo to throttle body-no intercooler.
oooooffft! lovely dose! 🤙🤙 (Get the assetto corsa modding turbo people on this asap!)
Love the zero fucks given down to earth production style of this channel. This is what we should show the aliens when they ask about human culture.
Whale dong intake pipe there made for a Honda , they tapered from 3inch to 5inch in the middle and back to 4inch at filter end
Ay, you boys should try the didgeridoo on the exhaust. That could be sick.
You guys blow at this .. Awesome work 👍
This is sick boys
Something like a 2stroke exhaust
there's a channel called "hardware unboxed", where he does a "fan showdown" where he 3d prints/benchmarks/scores PC fan blades that the community made and sent in. this could be your version of it.
as for suggestions for future dose tests, with added ascii diagrams:
1) the ball and shaft.
buy 2 cheap metal bowls and hole saw a spot for the pipe and exhaust, throw a bead of weld/rtv around it to make a ball. with this you can make a lollypop shape (---o) or a skewered (---o-) shape. test both to see the difference and ball at the tip or near turbo inlet.
2) The 2 stroke chump.
using a 2 stroke bike expansion chamber ---
3) Tentacle monster.
fill a normal pipe with several bendy metal conduit. lets say 8 conduits fills a 3 inch pipe, then the empty spaces between the conduit you fill with Rtv. you own little cthulhu intake. make the conduits equal length, but later try to change their lengths. like borla tunes their exhaust.
4) the stinker.
Take the usual pipe, then at the tip, add rubber hose/innertube slice. think of it like a whoopie cushion. farting car?
5) drunk dosage.
take a Heineken mini keg, hole saw it out and lets see how that baby sounds.
6. inception
make the pipe look like a VL. think pikachu bozo pipe but the air enters the top left point of V, the air then travels though the top of the L and down the lil leg. ----VL__
dose pipe suggestion, whole car exhaust and lets see if the mufflers, resonators and cats will muffle the sound!
I think if you put a small bit of steel at the clamp end of the pringles can it would be tremendous
Loop da loop dose pipe?
Need to do a anti surge housing vs t51r mod housing
the bazosoka was the best sound and you could even run it through the grill
Blow compressed air into the exhaust turbine on the double turbo set up see if it spools backwards or get one with a reverse rotation wheel in a normal rotation housing so its spinning the correct direction for the flow direction
Part 2 super trap off a motobike or a fmf pipe 😂😂 or how about a pipe with a end cap and 50 kazoo's 👌👌
Do like a 3inch 300mm pipe with a traffic cone on the end of it
sick vid as always
could try to stick an air compressor down the didgeridose pipe, combat some of the restriction and help her spool up
could let you boys try more silly stuff :p
for the turbo to work you need to invert the flow, so it feeds air in the right way!
Need a small straight thru muffler on it
The only way to draw a 2, JASSY is with us in the big boiz league
23:22 sounded like fh5
Thx for this video my friend, I will make the same in my car using a 3" PVC. Hugs from Brazil!
I think this is the best one
20:08
And These sound like forza
23:24 25:41
And this is all of them
26:39
The old Dosereydoo
pringles tube was sick but whats glass like? i reckon get a glass spaghetti container, glass cutter and knock the bottom off. tin tube would be siick too
Next time will be the flesh light dose pipe 😂
lol this is an interesting experiment and I am subscribed to your channel!
god i love these vids best sounds ever
Expansion chamber! So inlet dia--inlet (or smaller)dia again, dooo it for the dose!
How about a traffic cone?
Jasse is the most accurate replica of subaru impreza wrc pigeon chirping noise... From the 34mm fia spec turbo inlet restrictor
Now do weird exhaust exits 😂
im aussie and even i need subtitles when these spuds talk
Gotta try a supercheap cannon muffler
Can u do a loop next
4 to 1 exhaust collector. Quad dose pipe.
Last dose sounded like FH5 2jz highest turbo upgrade
Need the rubber chicken dose with a 2” pipe up the clacker
Should try 1inch stainless steel dose pipe then drill 5mil holes in the first inch of length on the pipe?
Do the turbo killer pipe and spray nitrous to get it up on the converter 👀 the dose would be UNREAL
Lmfao It's that sammit's picture on the wall 🤣🤣🤣
I wanna see a moose knuckle back into 1 pipe😯🤘🏻
you forgot the roadcone. that would be amazing maybe
You should try a foot long 3" box section 👀 get all square up in here 😂
Could do like the jassie but have then end sealed of the 4 inch tube with a 4 inch round plate and drill lots of little holes in the plate and call it the Cassie
Best channel ever on CZcams haha bought one if ya drag vl tees waiting for that Thang to arrive
idk why but when the other mechanic only watched 4 seconds, when you said "you, go back to work" i was like bruh
Can u do a tolite paper roll please
21:10 Reminded me of a Volkswagen
Dose all the way BRO!!! only 🧚♂️ fairy's fit BOV'S
Pringles mate hahah
next time you should really put in a one way valve, so that it wont try to suck the oil out of the seals
4 inch cone down to a 2.5 inch outlet. 30mm long. 100% Spice I reckon.
What do you think about making the turbo intake tube make 7 turns of 360 degrees, that is, a spring-shaped Pipe?
Put a muffler on the intake as a dose pipe
Try just the sillicunt connectors that you used to hold the pringles tube .
You should try the turbo on turbo action again by having a bit of hose on the other end of the compressor housing end going into the inter cooler straight into the turbo that way it spins the right way around and hopefully you will get a blooooooody mean dosey boi
How good was the PVC 👌🏻👌🏻 KANG dose for a few bucks
First PVC pipe 🔥
Try a can or two of beer stacked one after the other
Try a recorder.. Its a musical instrument
Can you see how much dose your bong makes?
22:04 I lost the plot ! :) :) :)
That is a Geelong man's 2 if I've ever seen one
Should try something in the shape of a traffic cone in different materials
20:30 wtf 🤣
Should try a 90 3inch with a hotdog muffler
Omg my suggestion got in xD
360 degree dose pipe
Please try a big traffic cone
Moos knuckle big disappoint. But now I want to see some 2" and 2.5" versions of the Jasse pipe since the 1" version and 1.5" digeridoo were too restrictive.
Glass dose pipe would be the best I recon
These have to be the funniest guys on youtube!
I have a fool prove setup of the audi quattro S1 chirping. Sounds incredible
I'm not surprised the turbo won't spool through a turbo that's flowing backwards 😅
T51r mod dose pipes next? Think pulsar sells one cheep to lol would be cool to see a stress test to
It's Pretty Ironic The Jassie Pipe Sounded The Most Excited Being Used 😉🤣
Best of the best video about flutter 😂😂😂😂😂 top !!