Great piece. I was thinking about making an adjustable plate loaded hammer out of 18in x 1in threaded rod, a cut pipe that would fit flush over the rod, some washers, and hex nuts. You could play around with the lengths of the handle length and add bigger sized washers if you were to add additional thickness to handle, then wrench both sides of the handle down using the hex nuts. My length of the handle would be around 10 in (that includes washers and hex nuts) leaving 8 inch of loading space not including a 3rd hex nut to tighten down the 1in plates. The only thing I have yet to figure out is adding a nylon strap to the bottom of the handle to add additional versatility even if it would shorten the handle length by an inch or so. If the strap were to be added I don't think a hex nut on the bottom of the handle would be necessary but instead, a cap of some kind or bit at the bottom drilled with a hole to screw the strap on each side.
That sounds like a cool project. I would think the shortened length could be compensated with using bigger load. Please make a video on your channel about it when it is all done. I'm interested to see it
That tool looks awesome, good job man.
Matt Mask
Matt Mask??
the scream of a true sisu
Magnificent war cries brother
Great piece. I was thinking about making an adjustable plate loaded hammer out of 18in x 1in threaded rod, a cut pipe that would fit flush over the rod, some washers, and hex nuts. You could play around with the lengths of the handle length and add bigger sized washers if you were to add additional thickness to handle, then wrench both sides of the handle down using the hex nuts.
My length of the handle would be around 10 in (that includes washers and hex nuts) leaving 8 inch of loading space not including a 3rd hex nut to tighten down the 1in plates. The only thing I have yet to figure out is adding a nylon strap to the bottom of the handle to add additional versatility even if it would shorten the handle length by an inch or so. If the strap were to be added I don't think a hex nut on the bottom of the handle would be necessary but instead, a cap of some kind or bit at the bottom drilled with a hole to screw the strap on each side.
That sounds like a cool project. I would think the shortened length could be compensated with using bigger load. Please make a video on your channel about it when it is all done. I'm interested to see it
Nonni kunnon rising aparaatti, et pelkkään remmiharjotteluun tyytynyt
Finnish accent?
Yes, I'm Finnish and living in Finland.
😅
Why the mask?
well he doens't want to show his face, if it isn't obvious for you
Him:to hide my face
AHAHAHAHA
you need a helmet to use this
haha! XD maybe