Whole House Surge Protector // Easy DIY Install
Vložit
- čas přidán 16. 04. 2024
- Step-by-step install of the Siemens FS140 surge protection device (SPD)
Siemens FS140: amzn.to/48GHTX7
Wire strippers: amzn.to/3843tuw
Non-contact voltage tester: amzn.to/3Q78t4g
** Warning: Electricity is dangerous. Do not attempt the procedures in this video if you're not familiar with electrical safety. Improper handling can lead to serious injury or damage. Always consult with a professional electrician. Your safety is your responsibility! **
This video includes Amazon affiliate links. I earn a small commission from qualifying purchases made through those links, at no extra cost to you.
Sub count: 176
Hi there. To answer a question below. Yes, they should be connected as close as possible to the power source(Power Service Disconnect) coming into the panel, when possible. A thing I did was similar to what you did when I installed mine. I used a threaded 1/2" npt pipe thread to 3/4" PVC connection as well, the only difference is I cut the pipe part off so it was just like a nut on the end. I then put the threaded part through the knock out into the FS140 I have so the unit is flush against the bottom of my panel. What you did is not wrong, I just think it looks neater tight against the panel. Thanks for the video! Cheers.
That's an awesome idea! Never thought of doing that. Yeah I bet it looks a lot cleaner that way. The shorter the better, that's great!
I didnt use the metal plate. It cost $100 which is ridiculous. Also installed mine inside my panel at the very bottom as thats where the only space for the 2 double 20 amp pole breakers are locbated. I cant see the SPD when i open the panel but the light shines through the spaces where the breaker is.
Unfortunately i have the Fs-100 and not the 140. Is it worth switching out???
What is the installation method if the breaker box is recessed in the wall with drywall around it. Will the surge protector fit inside the breaker box?
I think it would technically fit inside, at least in mine, but it's not really designed for that. Siemens does make a flush mount kit that you can use to mount it recessed in the drywall next to your breaker panel
There's also a more compact style of SPD that connects just like a breaker. That could be a good option if you have limited space. You'd just need to make sure you find one that matches the type of breaker your panel uses
@DustinDoesStuff
I am sure by now you have gotten your answer...but just incase. If your panel has enough space in it, it is perfectly fine to install it within. The only downside you have is you can not see the lights to be sure it's still working, but the PS140 also has an audible alarm too. Cheers.
Did the instructions indicate that the closer to the inlet voltage the better? Being in the bottom corner The Surge still has to pass all the other Breakers before reaching the bottom of the panel
I actually wondered the same thing but when reading through the instructions it didn't mention anything about that.
It did specify to "use closest breaker to SPD" and "ensure leads are as short and straight as possible". Per their instructions, I'm assuming those two bits are the most important factors?
But either way, with my panel I have network equipment on the upper right side and a transfer switch on the left. Plus the wires to the top breakers weren't left with hardly any slack so moving them lower into the panel would have been pretty messy with a lot of splicing. So the bottom seemed like the cleanest option for me.
I'd say if you can swing putting the SPD at the top to go for that! It does seem like the most ideal location would be closest to the inlet with having it come directly out one side