Easy DIY Beehive Inner Cover
Vložit
- čas přidán 28. 02. 2020
- Here is an easy way to build your inner covers for the Langstroth beehive.
Here is the air nailer/stapler I use throughout a majority of my videos
amzn.to/2OQtB2k
2"X4" boards 3.81cm X 8.89 cm
L=20" 50.8 cm
L=16 1/4" 41.275 cm
-------------------------------------------------------------------
Blade up 3/4" 1.905 CM
Inside of fence to outside of blade 1/4" .635 cm
--------------------------------------------------------------------
Inside of fence to inside of blade 3/4" 1.905 cm
Blade height just above board
--------------------------------------------------------------------
14 5/8" X 18 7/16" 31.15 cm X 46.83 cm
10 Frame Boxes
Thanks That Bee Man at Faith Apiaries for the safety tips the other day. - Zábava
Straightforward and to the point. Looks like a workable design. Thanks for sharing brother.
Massachusetts Prepper glad you like it. My goal was to do as simple as possible with the basic shop tools people would have and have it still be workable.
Massachusetts Prepper I like your channel. I added yours to the featured list on my channel. I figure people that subscribe to mine would like your channel as well.
@@GDHoneyAcresandCraftWork 👍
good vid, bro. way easy- fast- strong- effective!!
Nice push-block! I have the same one...Milescraft I think.
How would you notch the cover? Before installing the flat panel board? BTW - is that Luan?
I show you in the video with the table saw
Not sure what luan is but it’s a oak sheet in the middle because that’s what I had and used a 2x4 for the rest
@@GDHoneyAcresandCraftWork I did not see how you cut a notch into the end frame for an upper entrance.... I'll go back and watch again. Thx
@@MikeChamplin sorry I must’ve misread. The notched is in a different video. I just used a hand saw and wood chisel