Yamaha AV Receiver: How to Connect Speakers
Vložit
- čas přidán 23. 03. 2023
- I will show you step by step how to connect your speakers on the back of your Yamaha AV Receiver. In this video I will hook up 5 of them and a subwoofer.
↓↓Amazon links↓↓
►Replacement Remote Control for many Yamaha Receivers: amzn.to/3TBhjrx
►Yamaha WXC-50 MusicCast: amzn.to/3FEQvRw
●RECEIVER USED IN THE VIDEO:
►RX-V385 5.1-Channel 4K: amzn.to/3yS5jIP
The Amazon links above are affiliate, which means that I may get a small commission from them if you decide to buy something on their website. This is to support this channel :)
Don't forget to like and subscribe if this was useful to you! - Jak na to + styl
HERO ! This was incredibly helpful, thanks so much!
Just the video I was looking for.
Very Helpful, thanks
You are amazinf thanks a lot!!!
I did it all but my center speakers not working
I have a Bose Acoustimass 10 and there is a plug for Subwoofer Low Frequency Effects - my Yamaha receiver seems to not identify the Subwoorfer as LFE compatible - do you know if my RX-V673 and RX-V4A are compatible for the Bose Acoustimass 10 LFE plug? Thanks.
Which subwoofer you connected in the amplifier?
How long are the cables? Is It possible to use longer cables than the ones included in the box? THANK YOU!
Where do I connect speakers for Audio Only front center surround
I would put thicker cables and the subwofer between the two front 😊
From my understanding, subs are best utilized in corners of the room. And yes, thicker wires are almost certainly better for most audio setups.
4:47 😅@@FuriousTortoise
ok but how would you connect a wired sub to the pre out port? Can a banana clip work for that? I've had the Yamaha system for 10+ yrs and I am upgrading my receiver but as mentioned the sub connection isn't wired but pre out.
Great video. What is your speaker system?
I switched since then but I got those from an old Onkyo setup.
How much
hello..
I have yamaha avr
for the subwoofer. Must I have a powered subwoofer?
subwoofers are typically sold “active” (independently powered) because they’re the most power hungry speaker in your setup. Worse case when they’re playing some deep extended bass it can dull your main speakers by drawing a lot of power.
Does the receiver play sound itself or do you have to connect speakers?
You absolutely need speakers. This unit is just to amplify the sound, it does not make any sound by itself.
Bro it’s not working properly why??
Once played this Surround Right And Left And Surround Back Right And Left all signals Coming from Front Left and Right Both Tower Speakers.
The Sid Surround Left And Right And Back Surround Left And Right all signals going to Front Tower Speakers. But the Canter Channel is works fine on Right signals.
My connection is correct from the Receiver at Speaker terminal. Also I tested from my Receiver when I test that’s working fine everything on Right signals. But when I try to play on test videos from CZcams that time all Surround signals going to trough to the front Tower Speaker. What’s wrong???
I’m using the System is HTDDW8600 7.4 Channel System. It’s called Sony Super Muteki
What is the best audio setting for karaoke please help?
I have a subwoofer but not working 😭
Is that lamp wire you are using for speaker wire?? Not very confidence-inspiring!