Oil pump replacement Husqvarna 137

Oil pump replacement Husqvarna 36/136/137/142

[@itskata]

Very professional snd educational work!!! Good job

[@tusheeNaydenov]

Thank you very much!

[@mikemelo5568]

You dont want to put anything in the motor to block the piston... you can use a 13mm socket on the opposite side to hold the clutch from moving. This will prevent any damage to the piston

[@danielpadgett2831]

You can put a piece of nylon rope in there it wont hurt nothing or like he used a rubber piston stop

[@TheJagot]

Its happen to me. I destroy the conrod.

[@patrickfrazer9772]

Hey there, great video. When I tried this technique it worked to push the tab back, but then sprung right back to where it started. Does it every time and wont click in. Any ideas? Thanks!

[@kamerahegyi2813]

What about oilpump drive lubricating? Not neccessary?

[@tusheeNaydenov]

yes, it's not necessary, but if you consider putting a little grease it won't hurt

[@kamerahegyi2813]

@@tusheeNaydenov I am in a dilemma which is better, a clean but dry surface or a dirt trap with greasing.

[@MarkoMarkovic-ux8tu]

Kako je moguće da se uljna pumpa blokira od piljevine zar nema plastična zaštita sa druge strane

[@opticusmaximus]

Cleaning the parts not necessarily. 😳

[@danielpadgett2831]

Definitely needed a good cleaning

[@mrshure8984]

очень грязно - мог бы хотя бы продуть.