How to replace parking brake release handle on a Mercedes Benz C & E class W204 W212 and more

Sdílet
Vložit
  • čas přidán 30. 06. 2023
  • How to replace parking brake release handle on a Mercedes Benz C & E class W204 W212 and more models of Mercedes Benz

Komentáře • 30

  • @edosullivan7165
    @edosullivan7165 Před 5 měsíci +3

    Excellent, no messing about video. Thanks

  • @inmortem
    @inmortem Před 5 měsíci +1

    Thank god you posted this !

  • @carlovedev
    @carlovedev Před 4 měsíci

    Thank you very much!! It's been so helpful to me.

  • @pauloakley8424
    @pauloakley8424 Před 5 měsíci +3

    The hardest part is getting the screws back in while holding the lever out while trying not to pop the mechanism out

    • @SpacedOutGoatsGaming
      @SpacedOutGoatsGaming Před 5 měsíci

      Legitimately almost smashed the car up when I’ve been doing it in the rain just now 😂

  • @mandingowarrior4603
    @mandingowarrior4603 Před 25 dny

    After removing the two torx screws and I pull out the lever there is hardly any play in it and it comes out half of what yours did. Is there a simpler way to get more slack so I can have enough room to get the cable out of the broken piece..

  • @rymbougossa7449
    @rymbougossa7449 Před 4 dny

    Helloo, what if that grey wire snaped is the procedure more difficult or I can replace it myself?

  • @jozgatkayseri7350
    @jozgatkayseri7350 Před 6 měsíci +1

    Super wideo danke😊

  • @shahruddinmohamad2293
    @shahruddinmohamad2293 Před 5 měsíci

    Thanks a lot.

  • @barjunkies1
    @barjunkies1 Před 3 měsíci

    I carbon fiber my whole inside jus want to change pulling break I have carbon fiber 1 will this help

  • @karandeepsingh6666
    @karandeepsingh6666 Před 3 měsíci

    I just applied my emergency brake and i heard a click and my handle popped out of the dash. It not going in anymore and the emergency brake won’t hold no more. Any possibilities ?

  • @inmortem
    @inmortem Před 5 měsíci

    Can you link the video that you mentioned towards the end, regarding the E Brake and why they fail.

    • @mercland6434
      @mercland6434  Před 5 měsíci

      czcams.com/video/8IaCoEX8p-Q/video.htmlsi=z5GLx25Et04JsWWe

  • @naturallygreezy
    @naturallygreezy Před 3 měsíci

    Hi, do you know which size torx screwdriver you needed? I used t10 and t15 but they were too small.

  • @nesscog2287
    @nesscog2287 Před 6 měsíci +1

    Hi. I was stupid enough to press my P-brake during -15°C and something happened since the wire on the release handle jumped out and the handle itself. Now the P-brake wont engage on +7°C (i only did the 3 clicks with the hand) i mounted back the wire in to the release handle and it just stays pulled out. There is slight resistance on the wire so i guess it did not detach or jump off where it sits. What could have happened? Should i tried pressing the p-brake harder with my leg?

    • @TheCaptScarlett
      @TheCaptScarlett Před 3 měsíci

      Judging by other parking brake videos it;s a sticking spring/wire that needs WD40/grease _ i'll add a link

    • @TheCaptScarlett
      @TheCaptScarlett Před 3 měsíci

      czcams.com/video/Y3QTYjVFXSU/video.htmlsi=ny_a2vXIWknUfFF3

    • @TheCaptScarlett
      @TheCaptScarlett Před 3 měsíci

      czcams.com/video/Y3QTYjVFXSU/video.htmlsi=ny_a2vXIWknUfFF3

  • @robaydin
    @robaydin Před 4 měsíci

    hi my issue is the handle is loose now. is the cable supposed to be behind the hook inside the dash?

  • @joseluisromerojr8887
    @joseluisromerojr8887 Před 3 měsíci +1

    How do you get to the cable if it went in?

    • @mercland6434
      @mercland6434  Před 3 měsíci +1

      Above foot pedals, pull down the plastic trim which is held on with 3 torx screws. Then you should be able to find the cable.

    • @joseluisromerojr8887
      @joseluisromerojr8887 Před 3 měsíci

      @@mercland6434 thanks a lot for the quick response! Subscribed!

  • @christianhunter1366
    @christianhunter1366 Před 6 měsíci +1

    Any link to that part?

    • @christianhunter1366
      @christianhunter1366 Před 6 měsíci +2

      Sourced part from my local Mercedes dealer. £14. Replacing part is exactly as the video details. Putting screws back In can be a little tricky so a second set of hands is handy. Great video, super helpful. Thanks 🙏

    • @mercland6434
      @mercland6434  Před 6 měsíci +1

      Thanks! Yes it is best to buy from dealer. Cheap and correct first time!

  • @squidbeard5616
    @squidbeard5616 Před 2 měsíci

    people don't use the park brake? so what, they let the entire weight of the car rest on the gearbox while it is in P ?? that can't be good for the gearbox.

    • @mercland6434
      @mercland6434  Před 2 měsíci

      Unfortunately most people aren’t mechanically sympathetic as they aren’t aware. These people use phrases such as “turning my car on,” or “my car won’t work” or cannot differentiate wheels and tyres.