Drawing a BBS RA alloy wheel using Solidworks: Walk-through; Part 4

Part of a university project I am currently on.
This is not strictly a tutorial, it is just a walk-through of the making of the wheel.
The wheel is not dimensionally accurate; I created the whole wheel just using two dimensions (the width, 5.5j, and the diameter, 13"). All other dimensions have just been approximated.
In my opinion, it actually was rather successful, it at least serves it's purpose for my project, where it was used purely for show.
I stop talking after the first clip, the audio lags so much I cut it out completely.
Any advice/tips are greatly appreciated, Here I'm purely improvising as I go with the help of sketches.
The original images used:
i788.photobucke...
i8.photobucket....
The finished article:
i788.photobucke...
i788.photobucke...