It would be a good idea to strap that capacitor with either a metallic or plastic plumbers strap. Your work would look professional, and the capacitor will not move.
Very good video, I have a ECN furnace motor and had to replace it twice 250$ each time. What is the number for the relay and I have saved this video so I can make sure I wire it right. Thanks
What about a new gas furnace with a board that has a time delay that starts the motor? In the old days you put the "Heater Speed" on the normally closed set of contacts because the fan switch would bring on the fan.
Nicely explained 👍🏻👍🏻
Good job although I don’t like a cap in a box always strap it thanks for the video
It would be a good idea to strap that capacitor with either a metallic or plastic plumbers strap. Your work would look professional, and the capacitor will not move.
Very good video, I have a ECN furnace motor and had to replace it twice 250$ each time. What is the number for the relay and I have saved this video so I can make sure I wire it right.
Thanks
Nice change out , on that crusty one. Mr grinch . Thanx
Perfect thank you
New subscriber, great job brother
What about a new gas furnace with a board that has a time delay that starts the motor? In the old days you put the "Heater Speed" on the normally closed set of contacts because the fan switch would bring on the fan.
👍🏼
Will the heater work if need it?
Been doing it for years
I just use a QwikSwap X1
@wd8557 - Does the QwikSwap X1 run both the heater and the A/C? Also, does it have a built-in delay? Thanks.