The rail is very hard to get ahold of! I had to buy one ripoff merchant on ebay for £250. I managed to find a second from a local scrap yard for £20! My side door isn't locking normally so I will try cleaning the pins, inspecting the connection points. Didn't know about the button the alarm does seem to go off at random. One note a mechanic told me to never put oil based grease on these types of rails. As the rollers are rubber, you should use dry silicone based lubricant.
Another great video 👍 it's worth adding that the sockets the door locating pins go into will be worn if the door has dropped. You can adjust these upward very slightly to allow for drop. If replacing the middle rollers use a jack to hold the door at the right height if you've no one around to help.
I have a wider gap on top right of the door than the left meaning when you shut the door it hits the top of the passenger door. Any ideas how thats put right ? thanks, Tony
Hi. I have a 2006 Master Automatic Motorhome. The engine stop warning light is flashing continuously. I have had it looked at by three different businesses; two said a faulty ECU, the last said genuine faults, but couldn’t find the codes and he tested it for three hours. It’s only done just over 30,000 miles and runs well, apart from greyish smoke for the first 5 minutes after starting. I haven’t got a clue what to try next , so any suggestions would be greatly appreciated. Cheers Tony
The rail is very hard to get ahold of! I had to buy one ripoff merchant on ebay for £250. I managed to find a second from a local scrap yard for £20! My side door isn't locking normally so I will try cleaning the pins, inspecting the connection points. Didn't know about the button the alarm does seem to go off at random. One note a mechanic told me to never put oil based grease on these types of rails. As the rollers are rubber, you should use dry silicone based lubricant.
Another great video 👍 it's worth adding that the sockets the door locating pins go into will be worn if the door has dropped. You can adjust these upward very slightly to allow for drop. If replacing the middle rollers use a jack to hold the door at the right height if you've no one around to help.
Thx Richard for you kind comments and your good tip on the locating pins.👌
I have a wider gap on top right of the door than the left meaning when you shut the door it hits the top of the passenger door. Any ideas how thats put right ? thanks, Tony
Carefully check the rollers, and the track they roll on, if all OK then make some adjustments I suggested in this video, hard to help via messages.
Hi. I have a 2006 Master Automatic Motorhome. The engine stop warning light is flashing continuously. I have had it looked at by three different businesses; two said a faulty ECU, the last said genuine faults, but couldn’t find the codes and he tested it for three hours.
It’s only done just over 30,000 miles and runs well, apart from greyish smoke for the first 5 minutes after starting.
I haven’t got a clue what to try next , so any suggestions would be greatly appreciated.
Cheers Tony
Did the 1st two mechanics say faulty ecu because they couldn't connect with it to gain any fault codes stored?