A good degrease and 30 minutes in an ultrasonic bath will have those gleaming. Biggest issues I've found with those carbs is the float valves gumming up and leaking petrol all over the place.
I am not sure if you pulled the air jets - I generally turn then back in and count how many turns they are set at before removing them - Coming along though I think that you will have fun with that little bike
Best video I've found! Thank you!
Glad that you found it useful mate.
Looking forward to the first start on this one.
Not as much as I am! Just got the get the start sorted first!
🏍👍
💪👍🏍️
❤
🏍️💪
A good degrease and 30 minutes in an ultrasonic bath will have those gleaming. Biggest issues I've found with those carbs is the float valves gumming up and leaking petrol all over the place.
To be honest mate, I ended up stripping them to individual carbs and squeezing them into my ultrasonic individually!
@@NatsNackersYard I used to do that then I fried it so bought a bigger one... 😆
I am not sure if you pulled the air jets - I generally turn then back in and count how many turns they are set at before removing them - Coming along though I think that you will have fun with that little bike
Thats the mix screw mate, not the jets themselves. Not all bikes have air jets (pretty sure that my gpz didn't).
Hint for a small ultrasonic and 4 x carb bodies…… wait until the wife’s out and chuck them in the dishwasher
There's a fine line between braver and stupidity. I have been known to cruise that line!
Good vid ta. Numpty question - was that a JIS driver for the "pozi" screws? I suppose I'm asking, do I need a decent set of JIS drivers? Cheers, Andy.
I think that they are all JIS screws mate. I bought a cheap set a while ago and they are so much better, especially on carbs.
@@NatsNackersYard 👍ta
A clean will do more good than harm Nat ,are you going back to standard mains?
Probably, eventually. I have got to get it running before I make that call I think. Maybe it was upjetted for reason.