This is an annual customer and we did the whole package. The AR45 gas pump put in some work with the 12 volt for the roof wash. Check out our channel / @allproexteriorservice...
Hey big dog love your videos.. I have a question. I’m curious if you have ran a 24 volt for washing before.. and if you think it would have enough flow to do the rinsing side as well..just to get started of course only untill I get a pressure washer later for rinsing.
The 24 volt pump should give you more volume. I would maybe look into the 7 GPM 12 volt pump & save the additional money for a pressure washer. Once you get the pressure washer then you can downstream which should be more efficient. Thanks
Great content! I’m getting my SW system tomorrow with the AR45. Do you always wet brick with water before you use SH? Will the SH damage the brick if you don’t pre wet? Also, what percent of SH do you use for a regular house wash?
On my ar i feel like im not quite getting what my valves say i am. Im using a regular ball valve for water which stays open but my bleach is an asahi metering valve. Im not really able to pull bleach until a bump under 50%. Im stumped as to what I'm doing wrong.
I started with a regular ball valve on the water side. I ended up changing the water valve to an Asahi metering valve and it is way more accurate. The regular ball valve will flow more than the metering valve. Hope this helps. Thanks
Sup Buddy! Good to see ya out here getting it!
Thanks brother!
So don’t you use much more sh using the AR 45 then downstream
No sir. I use the same amount to wash a house, just more efficient for us. Thanks
Hey big dog love your videos.. I have a question. I’m curious if you have ran a 24 volt for washing before.. and if you think it would have enough flow to do the rinsing side as well..just to get started of course only untill I get a pressure washer later for rinsing.
The 24 volt pump should give you more volume. I would maybe look into the 7 GPM 12 volt pump & save the additional money for a pressure washer. Once you get the pressure washer then you can downstream which should be more efficient. Thanks
Great content! I’m getting my SW system tomorrow with the AR45. Do you always wet brick with water before you use SH? Will the SH damage the brick if you don’t pre wet? Also, what percent of SH do you use for a regular house wash?
I wet the brick because I find it easier to rinse the SH off. It should not harm the brick. I am using about 1% for a house wash. Thanks
On my ar i feel like im not quite getting what my valves say i am. Im using a regular ball valve for water which stays open but my bleach is an asahi metering valve. Im not really able to pull bleach until a bump under 50%. Im stumped as to what I'm doing wrong.
I started with a regular ball valve on the water side. I ended up changing the water valve to an Asahi metering valve and it is way more accurate. The regular ball valve will flow more than the metering valve. Hope this helps. Thanks
@@allproexteriorservicesllc5338 Now that you mention that i was wondering about the cut vs uncut. That’s probably a substantial difference.