How To series - Setting height of cut on a cylinder mower
Vložit
- čas přidán 3. 07. 2020
- It is important to check your height of cut before use, not just to set the height when required to make sure you keep an even cut. This article explains how to set the height of cut on a pedestrian cylinder mower.
SUBSCRIBE and LIKE today’s video & Turn On Notifications for New Videos - / pitchcare1
#howtoseries #mower #pitchcare #heighofcut #learning #maintenance
Was at course with aquagauge moved to new one without, very helpful thanks.
Great video and well presented.
Looking great
Good video
Thank You Mick hope it helped :)
Love the video. Is there any reason why the height could be set different at each end? Just measured mine after making a bar and it's about 5mm different.
Cheers
did you figure it out Master Shredder ? mine has diff heights too
@@13hickory yeah mate, the rear roller was out. Made it parallel to the bed knife and chassis, then set the height. It's within about 0.5-1mm.
Hou van die videos. Waar is jy gelee?
What is the difference between the Atco Balmoral 14sk and the Qualcast Classic 35s, apart from the engine. How much would you expect to pay for a good Balmoral.
Hi, do you sell the setting bars?
No Simon, but thanks for viewing