Using a trashed piston and ring to remove dry cylinder liner on Isuzu 4JB1 from Bobcat 853

I bought a “Vevor Liner Puller Cylinder Liner Puller Dry And Wet For 75-138 Mm Diesel Engine” kit that had adapters for 85-90mm and 95-100mm. My liner was 93mm, so I had to improvise.
You’ll need a trash piston, trash ring, ring compressor, and a shop press. Likely could use a hammer and a drift rod, if you don’t have a shop press, but I didn’t try it.
Bobcat part for liner is 6631853
Isuzu part for liner is (I think) either 8-97176-685-0 or 8-94247-861-2

[@jmvoltrino]

Curious what you used to install the new liner? Did you buy a tool, or just a flat plate and a hammer/press?

[@rosemccann6942]

I have a bobcat 853 with low compression wandering where did you source your parts from? And was wandering if you had a video of cylinder liner installation?