You're like the smartest black fella doing these kinds of videos. Good light, straight to the point. Do this, that, this, that. And you're finished. I'm quite used to HP/Canon/OKI laser printers. But now I'm probably going to change transfer belt on on Kyocera for the first time. So watching decent guide always helps, saves time and prevent accidental damage. I really hate common CZcams 20 minute videos of nothing, mumbling, shaking cell phone camera, lots of shade, hands in the view.
I hope you figured this one out, but in case you or someone else runs into this problem, you have to remove the cartridges as well otherwise it remains locked in place.
@@DedicatedDdos exactly well said, front screws should be open, the mp tray shut, toner containers out, back two screws out then unplug the front cables thats it.
@@vikinycyber8928 Sir Please can i get a video on how i can disconnect it and make my printer work again because it keeps on writing maintainer failure call 6000
That worked perfectly, thanks a lot. Finally good prints again and millions saved on a service guy 👍
You're like the smartest black fella doing these kinds of videos.
Good light, straight to the point. Do this, that, this, that. And you're finished.
I'm quite used to HP/Canon/OKI laser printers. But now I'm probably going to change transfer belt on on Kyocera for the first time.
So watching decent guide always helps, saves time and prevent accidental damage.
I really hate common CZcams 20 minute videos of nothing, mumbling, shaking cell phone camera, lots of shade, hands in the view.
thanks for your help 👍
thank you for your feedback.🙂
Thanks !! 👍
Ajudou bastante.
Don’t know why but after unscrewing everything the drawer won’t come out, it’s like there should have been another screw somewhere else
I hope you figured this one out, but in case you or someone else runs into this problem, you have to remove the cartridges as well otherwise it remains locked in place.
@@DedicatedDdos exactly well said, front screws should be open, the mp tray shut, toner containers out, back two screws out then unplug the front cables thats it.
I am still facing the same issue, the drawer won't come out, I followed all the steps and took the toners out
@@cedriccarabin7009 I suppose you have pulled out that lock next to the drawer connector(grey) on the front side.
same issue here??
Hello sir
I need your help, my printer is not printing writing maintaner failure call 6000.
What can i do
Hallo to you, was there power issues in your area?
If not you better disconnect the fuser unit at the back door and check if there is a visible fault or broken gear...
@@vikinycyber8928
Thank you so much for replying me sir
Okay i will do just that .
@@vikinycyber8928
Yes sir
@@vikinycyber8928
Sir
Please can i get a video on how i can disconnect it and make my printer work again because it keeps on writing maintainer failure call 6000