I am also a Chinese bearing factory. I admit that there are many bad Chinese bearings, but we produce our own brands and make high-end products, because we know enough about bearings. We have been doing it for more than 20 years, so I dare to say that our brand is definitely the most cost-effective. We will provide suitable products according to your working conditions
@@Downunder4gold I am also a Chinese bearing factory. I admit that there are many bad Chinese bearings, but we produce our own brands and make high-end products, because we know enough about bearings. We have been doing it for more than 20 years, so I dare to say that our brand is definitely the most cost-effective. We will provide suitable products according to your working conditions
It is the principle of heating the bearing through grease, thermal expansion and contraction. After the bearing is cooled, it will fit naturally. Most of the bearing installation is like this.
It is the principle of heating the bearing through grease, thermal expansion and contraction. After the bearing is cooled, it will fit naturally. Most of the bearing installation is like this.
I'm not sure if the clearance is right on that
I think this was installed by heat that's why the fit looks off, but when the bearing cools it will shrink on the shaft.
Yes, it is heated by grease
It would be HOT then
@@陈菲bearingor an induction heater
Shaft bearing seating area metal under cutting,
from bearing what bro
In this Sleeve are not use so bearing can damage quickly.😊
Itna dhila size
Where is the taper sleeve? I know very well that bearing didn't went to the bearing heater 1st he wouldn't have held it like that 😂
Chinese Bearing, Not skf
i prefer buy DWB, instead buy the fake SKF
I am also a Chinese bearing factory. I admit that there are many bad Chinese bearings, but we produce our own brands and make high-end products, because we know enough about bearings. We have been doing it for more than 20 years, so I dare to say that our brand is definitely the most cost-effective. We will provide suitable products according to your working conditions
@@Downunder4gold I am also a Chinese bearing factory. I admit that there are many bad Chinese bearings, but we produce our own brands and make high-end products, because we know enough about bearings. We have been doing it for more than 20 years, so I dare to say that our brand is definitely the most cost-effective. We will provide suitable products according to your working conditions
Looks like ALOT of play and why is he able to lift it without burning himself
That clearance is way too much
Why inner ring going free?
It is the principle of heating the bearing through grease, thermal expansion and contraction. After the bearing is cooled, it will fit naturally. Most of the bearing installation is like this.
❤
Hello, I am a manufacturer of automotive wheel hub bearings
Heat kr ke dal raha hai
Aaa, so the axel shall go into the hole, nobody could figure that out.
cilindrical not spherical
كل حلوة مع. الزاق انتتتتت SXBPQ
is that clearance fit ?
It is the principle of heating the bearing through grease, thermal expansion and contraction. After the bearing is cooled, it will fit naturally. Most of the bearing installation is like this.
Bhut dela h
holy fuck turn the goddamn music volume down