Setting Air Gap on Hydraulic Release Bearing Tilton 6000 Series

I show you how to install and set the air gap needed for your Hydraulic Release Bearing. I used a Tilton 6000 Series Hydraulic Release Bearing.
Other tools needed:
1/2" wrench
12" Combination Square rstyle.me/+qi3...
6" Digital Calipers rstyle.me/+kV2...
Torque Wrench rstyle.me/+jvk...
Tilton 6000 Series Hydraulic Release Bearing tiltonracing.c...

[@BoostedPj]

Great vid

[@bchaveezy]

Got some good helpers there, good job

[@godzillagarage7.3]

Awesome, I am installing the same bearing in my tkx

[@josevaldez9043]

This is crazy i just measure my bellhousing and it give me 2.28

[@powerviking]

I just did this on my T56 in my terminator, and had to put a spacer in between the threaded internal collar and the face of the transmission to keep the collar from pushing on the bearing retainer. Did you end up putting something in there as well?

[@turboman351w3]

hey my friend what slave cylinder are you using

[@19jody72]

How is that Tilton htb holding up?

[@powerviking]

I'll second that!

[@rossdean1061]

That's so confusing...use metrics it's so much easier

[@Ritston99]

That only works if it’s a precision straight edge

[@tylerseabook9423]

Literally as simple as 50 minus 30 if you did this in millimeter’s 🤦‍♂️ the metric system is so much easier. Obviously that’s just an example but if you did this in millimetres it be as simple subtracting two different numbers that would be under 100.😂