Hello sir.. Actually now I am working in a project..in that project I should have to shown beams and also door openings in plan view..beam will be in an one height..and openings are below that beam..so I just make it a separate plan regions for each beams because huge number of openings are there ... so I made a view ranges based on door openings and for beams plan regions are created as I said before..but as like this floor I have followed to another floors also..but there I couldn't see any beams even I used plan region.. could you plz help me to sortout this sir??
Each floor may need a different settings for plan regions. You'll need to check settings in the new floor and adjust if necessary. Also, consider changing the view range of the entire floor plan instead of using individual plan regions :)
Thanks for a lesson.
Thanks for attending my lesson! ;)
This was very helpful, but I think you are doing manual changes on every sheet. So please show how this will look in the Drawing Index.
How to wrap the long sheet number in 2 lines if required?
You can edit the section head family and make the text box in there shorter. It will then auto-wrap texts longer than the box.
@@RVBoost Thanks, for some reason its not working. I tried to edit all - section head, callout head but the text still dont wrap.
Then you may need to use the trick in this video instead to shorten the sheet number :(
Hello sir..
Actually now I am working in a project..in that project I should have to shown beams and also door openings in plan view..beam will be in an one height..and openings are below that beam..so I just make it a separate plan regions for each beams because huge number of openings are there ... so I made a view ranges based on door openings and for beams plan regions are created as I said before..but as like this floor I have followed to another floors also..but there I couldn't see any beams even I used plan region.. could you plz help me to sortout this sir??
Each floor may need a different settings for plan regions. You'll need to check settings in the new floor and adjust if necessary. Also, consider changing the view range of the entire floor plan instead of using individual plan regions :)
@@RVBoost ok..sir..thank you..😊