Viper 5160 Training Video

Sdílet
Vložit
  • čas přidán 12. 09. 2024

Komentáře • 30

  • @jollylord755
    @jollylord755 Před 2 lety +2

    We just got these at my job and I must say keep doing what your doing beacuse you’ve sold me on it!

  • @liamthemarchingbandguy4063

    We have that same floor scrubber at the grocery store I work at

  • @pyrokamileon
    @pyrokamileon Před 2 lety +2

    I could not figure out how to drop down the brush using the foot pedal! But thankfully I saw you push it to the side and then I tried that on our own Viper and it worked right away! thank you! 👍🏽

  • @ronnierodriguez3876
    @ronnierodriguez3876 Před rokem +1

    Do you have a video that shows at the end of scrubbing the daily cleaning of the machine. Plus can you show solution recommendation to put in machine and ratio of solution. Is cold water ok or should we fill with hot or warm water for better results? How to change or flip vacuum rubber/pink squeegee?

  • @brayanposada6944
    @brayanposada6944 Před 9 měsíci

    Me puedes ayudar porque en el panel de control los bombillitos donde muestra la carga quedan con una falla intermitente y no deja funcionar la maquina que falla seria y después de un día sin uso vuelva a su estado normal

  • @806rodriguez4
    @806rodriguez4 Před rokem

    What does it mean when the three indicator lights are on but it’s not catching charge

  • @ronnierodriguez3876
    @ronnierodriguez3876 Před rokem

    Btw I could do school dining room in minutes instead of mop and bucket that just spreads the dirty surface. The 20 inch swath easily glides in kitchen prep areas and serving lines.

  • @taoher9142
    @taoher9142 Před 3 lety +1

    I have never been able to seat in my pad driver for some reason. Only one of the 3 spokes gets in and it becomes lop sided, also stuck and won't kick off when I press the bottom to release the pad. What am I doing wrong?

    • @Caliberequipment
      @Caliberequipment  Před 2 lety

      An alternate way of seating the pad driver, would be to place the pad driver on the floor, lower the deck onto the pad driver, wiggle the machine back and forth until you see the deck drop into the pad driver, then turn the machine on and it should lock it into place. If you still need assistance, give us a call at 1-888-550-0945 and we can help troubleshoot the issue further.

  • @Irishrebel092
    @Irishrebel092 Před 6 měsíci

    What is the strongest concrete cleaner that can be put into the machine?

    • @Caliberequipment
      @Caliberequipment  Před 6 měsíci

      Anything except chemicals with a bleach base, or a high Ph or high foaming ingredient. These types of chemicals can damage the machine.

  • @LTFoh3
    @LTFoh3 Před rokem

    How long does it take to charge a brand new battery from red light to full charge? Also does the machine needn't be kn or off when it's charging?

    • @Caliberequipment
      @Caliberequipment  Před rokem +1

      A general rule for battery charging is that it will take double your runtime to charge the battery to full - So for a brand new battery you'll get an average of 2.5 hours runtime, so your charging time would take 5 hours. The Viper 5160 will automatically shut itself off when plugged in to charge. Hope that helps!

  • @reneramirez2049
    @reneramirez2049 Před 2 lety

    Running dry no water coming through I clean the filter in bottom of tank still very little water coming through also no dirty water on recovery tank any Send it to get it service but got back still not working any suggestions

    • @Caliberequipment
      @Caliberequipment  Před 2 lety

      Try removing the filter and checking for blockages in the hole at the bottom of the tank. Or it could be a defective solenoid. Try checking the passage between the solenoid and brushes for any residue. If you need further help, give our service dept a call at 1-888-550-0945

  • @melinamendoza7743
    @melinamendoza7743 Před 11 měsíci

    Is there a way to drain the fresh tank?

    • @Caliberequipment
      @Caliberequipment  Před 10 měsíci

      Down at the bottom of the machine there is a drain cap that will let you drain the fresh tank. Check your owners manual for the exact placement.

  • @jtc168
    @jtc168 Před 3 lety +1

    Whats the run time for the battery?

    • @Caliberequipment
      @Caliberequipment  Před 3 lety

      2 - 3 Hours on a standard battery pack. Runtime on all scrubbers will vary depending on the age of the batteries, the down pressure on the pads, and the particular surface you are cleaning.

    • @jtc168
      @jtc168 Před 3 lety

      @@Caliberequipment thank's

  • @howardwillie6031
    @howardwillie6031 Před rokem

    Whenever I stop the it just takes off just like that and it is new that is a problem

    • @Caliberequipment
      @Caliberequipment  Před rokem

      It sounds like one the paddle buttons on the handle might be getting stuck? Contact your seller because it might be covered under warranty.

  • @joeclavelli6240
    @joeclavelli6240 Před 3 lety

    Is there any way to drain the clean/soapy water reservoir?

    • @Caliberequipment
      @Caliberequipment  Před 3 lety +1

      In the back of the machine, you will see a filter cup - If you remove it, the water reservoir should start draining. Let us know if that helped!

  • @sergioair1
    @sergioair1 Před 4 lety

    Where the soap goes???

    • @Caliberequipment
      @Caliberequipment  Před 4 lety

      In the front of the machine, where you put the clean water.

  • @jorgeenriquebarbosa3892

    En rspañol

  • @PapawFenix
    @PapawFenix Před 2 lety

    Unclear on how to drain clean water.

    • @Caliberequipment
      @Caliberequipment  Před rokem

      Underneath the bottom of the tank there should be a screw-off cap. Also if you remove the filter, that should drain the clean water.